Loading ...
Loading ...
Loading ...
6
www.linarie.com.au
cont. installation
The adhesive that join the plastic or wooden material of the furniture,
MUST be heat resistant of not below 150ºC.
Be sure the work surface is square and level, and no
obstruction with space requirements.
The work surface is made of heat – resistant and
insulated material.
If the hob is installed above an oven, the oven must have
a cooling fan.
The installation will comply with all clearance require-
ments and applicable standards regulations.
A suitable isolating switch providing full disconnection
from the mains power supply is incorporated in the
permanent wiring, mounted and position to comply
with the local wiring rules and regulations.
The isolating switch must be on an approved type and
provide a 3 mm distance that separate all poles
or in all active phase conductors if the local wiring
rules allow for this variation of the requirements.
The isolating switch will be easily accessible to the
customer with the hob installed.You consult local
building authorities and by- laws if in doubt regarding
installation.
You use heat resistant and easy to clean finishes such
as ceramic tiles for the wall surfaces surrounding the hob.
The power supply cable does not come in contact with
cupboard doors or drawers.
There is adequate flow of fresh air from outside the
cabinet to the base of the hob.
If the hob is installed above a drawer or cupboard space,
a thermal protection barrier is installed below the base
of the hob.
The isolating switch is easily accessible.
Gently place the unit on a stable and smooth surface.
(You can use the packaging.)
Do not apply force on the controls that showed from
the hob.
Gently place the appliance on a stable and smooth surface
(use the packaging). Do not carry out any physical
force on the control panel of the appliance.
The rear wall, adjacent and surrounding surfaces must be able to withstand a temperature of 90°C.
4.2 Before Installation
4.3 After installation 4.4 Before locating the fixing brackets
4.5 Adjusting the bracket position
1.
Install and fix the brackets on the appliance
as shown.
Screw
Screw
Worktop/ cupboard
Bracket
Glass
Bracket
Screw hole
Bottom/ housing
2.
Insert and align the appliance into the installation
opening.
3.
4.6 Caution
1. The ceramic hotplate must be installed by a qualified personnel or technicians. We have professionals at your service.
Please never conduct the operation by yourself.
2. Do not install the hob directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as the
humidity may damage the hob electronics
3. The induction hotplate shall be installed such that better heat radiation can be ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the middle layer and adhesive must be resistant to heat.
6. Do not use a steam cleaner.
Loading ...
Loading ...
Loading ...