Loading ...
Loading ...
Loading ...
6
Connection external motor version.
In external motor version it is necessary to
connect the cable of the external motor to the
corresponding connection in the hood.
If the connection from the external motor has
two plugs, it is necessary to remove the cover
of the bipolar connection before installation.
Fixing the ornamental chimney
* Before xing the chimney, place the electric
feeding equipment into the ornamental pipe
and provide it with a hole for the air outlet if
the appliance is used in its sucking version.
Warning!
Before connecting the exible exhausting pipe
to the motor, make sure the stop valve, which
is on the air outlet of the motor, can swing.
Sucking version
* Fix the pipe-bearing stirrup (Fig. 7Y) to the
wall or ceiling by using the proper reinforce-
ments and screws in equipment. Connect the
cooker-hood ange with the evacuation hole
by using a proper pipe.
Put down the lower pipe while paying attention
it is being properly introduced into the hood.
Perform the electrical connections. The superior
end of the pipe is to be xed laterally to the pipe
bearing (Fig. 8Y) by using the two self-threading
screws. Now mount the inferior chimney by in-
serting it through the front side of the cooker
hood and then turning it down until it is xed
inside (Fig. 8).
Filtering version
* In the ltering version the air deviator is xed
through the screws supplied (Fig. 9), by using
the holes which are on the back of the upper
telescopic section. Connect the ange of the
appliance with the air deviator through an ap-
propriate pipe. Connect the appliance with the
electric mains. Connect it to the display cable
strap. Put down the lower pipe while paying
attention it is being properly introduced into
the hood.
Fix the upper chimney as indicated in bic. 8.
INSTALLATION
Before installing the appliance, make sure
that none of the parts is damaged in any way.
In case of damaged parts, contact your retai-
ler and do not proceed with installation.
Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe bends.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in pipe section
(recommended constant diameter: 150 mm
or equal surface area).
* Before installing the appliance, in order not
to damage the appliance itself, the metal gra-
se lter should be removed. Such lter can be
removed by pushing the special lter handle
toward the back side of the cooker hood and
turning it downwards so to unfasten it from
its slot (Fig.3B).
Wall stirrup-xing
* By using the special drilling jig (Fig.4X),
perforate the wall according to the pattern
indicated by the jig itself, and pay attention in
order not to damage water pipes and electric
wires. Perforation should be performed with
a Ø 8 mm wall-drill. Then insert into the
proper plastic reinforcements (Fig. 4A). The
hood-bearing stirrup (Fig. 4S) can be applied
by using the screws provided with the equi-
pment (Fig. 4B). Now hook the cooker hood
onto its bearing (Fig. 5) and then adjust hori-
zontally and vertically the position of the ap-
pliance by acting on the special metric screws
(Fig. 6V,T).
After the appliance is adjusted, x it by in-
serting and tightening the safety screws pro-
perly (Fig. 4C).
WARNING: Failure to install the screws or
xing device in accordance with these in-
structions may result in electrical hazards.
Loading ...
Loading ...
Loading ...