Loading ...
Loading ...
Loading ...
The hood comes with plugs suitable for most
walls / ceilings. You should however consult a
qualified technician to make sure the installation
is suitable for your kind of wall/ceiling. The
wall/roof should be sufficiently strong to support
the weight of the hood.
Before installation:
• Check that the product purchased is the right
size for the area where it is to be installed.
• To make installation easier, temporarily remove
the grease filters and other parts that can be
removed whose dismantling and assembly are
described here. These should be refitted when
installation is complete. See the relative
paragraph for dismantling.
• Remove the active carbon filter/s if provided
(again consult relative paragraph). This/these
should be re-assembled only if you wish to use
the hood in the recirculation mode.
• Check that there are no parts (e.g. bags with
screws, warranty) inside of the hood (for
transport reasons). If there are, remove them
and put to the side.
• If possible, disconnect and remove the
surrounding units and those near the
installation area of the hood so that you have
better accessibility to the ceiling / wall where
the hood is to be installed.
Otherwise, protect the units as much as
possible and all the parts relating to the
installation. Choose a flat surface and cover it
with some protection where you can place the
hood and parts.
• Disconnect the hood by turning off the mains
switch in the house whilst connecting the
electrics.
• Furthermore, check that near the area where
you are installing the hood (in an area
accessible even when the hood is fitted) there
is an electric socket and that you can connect
to an extractor towards the outside (only in
the venting mode).
• Carry out all the building work necessary (e.g.:
installation of an electrical supply and/or hole
to pass the venting pipe through).
This kind of hood must be inserted into a
cupboard or cabinetry for support.
• The hood could be used with gas/electric or
induction hobs.
Fig. 3
Cut a slot on the bottom of the cupboard
according to the measurements shown.
Cut another hole on the top of the cupboard for
the venting pipe and power lead.
Installation
All measurements in mm
9
All measurements in mm
Loading ...
Loading ...
Loading ...