Loading ...
Loading ...
Loading ...
ASSEMBLY / PRE-OPERATION
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 8 and 9)
1. Install remote cable bracket to discharge chute with
5/16-18 carriage bolt, 5/16 flat washer and 5/16-18
Iocknut as shown. Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon friction washer and 1/4-20
Iocknut as shown. Tighten securely.
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown.
CHUTE SPRING 1/4-20
SHOULDER
NYLON BOLT
FRICTION
WASHER HOOK BETWEEN
CABLE HEX NUTS
EYELET ON CHUTE
ROTATER HEAD
REMOTE
CABLE
5/16-18
CARRIAGE
BOLT
_16 FLAT
WASHER
_16-18
LOCKNUT
FIG. 8
\
\
/'
/ ///
f
CHUTE DEFLECTOR
\
CONTROL LEVER
\
\
L i
FIG. 9
INSTALL WEIGHT BAR (See Fig. 10)
Though seldom required, the weight bar will reduce the
tendency of the auger housing to ride up on hard, icy drifts.
Should conditions require it, install as follows:
1. Shut off engine and wait for all moving parts to stop.
2. Secure weight bar to auger housing with carriage bolts
and hex nuts as shown. Tighten securely.
WEIGHT CARRIAGE
HEX NUTS
AUGER HOUSING
FIG.10
CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated atthe fac-
tory for shipping purposes. Correct and equal tire pressure
is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI.
Loading ...
Loading ...
Loading ...