Loading ...
Loading ...
Loading ...
Caution
Toavoid property damage, observe the following:
• Confirm water pressure to water valve is between 20
and 100 pounds per square inch.
• Tighten nut by hand to avoid cross threading. Finish
tightening nuts with pliers and wrenches. Do not
overtighten.
• Check for water leaks and correct if necessary
before returning refrigerator to normal location and 24
hours after connecting.
Important
• Before connecting water supply, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Aself-piercing or3/16'' saddle valve is not
recommended. Both reduce water flow, become
clogged with time and may cause leaks if repair is
attempted. The correct type of shut off valve requires
a %" hole to be drilled in water supply pipe prior to
valve attachment. The manufacturer isnot responsible
for property damage caused by improper water
connection.
Materials Required
V4"(6 mm) flexible copper tubing. Length of copper tubing
must reach from water supply connection plus an
additional 8' (2 m)for service loop behind refrigerator.
Procedure
1. Remove plastic cap from water valve inlet port. Place
brass nut and brass sleeve on copper tubing. Insert
copper tubing into water valve inlet port. Connect
brass nut on copper tubing to water valve inlet port.
Confirm copper tubing is secure by pulling on copper
tubing.
c_
o
B
A
.
.
4.
5.
.
Create service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator
cabinet with a "P" clamp.
Plug in power cord.
Move refrigerator into final location.
Level refrigerator and align doors.
a.Remove toegrille.
b.Turn roller adjustment screw to raise or lower
refrigerator cabinet until refrigerator is stable. Some
models have both front and rear adjustable rollers.
c.Models with Hinge Adjusting Cam
If tops of doors are not aligned after leveling, loosen
refrigerator door hinge screws _/2turn. Turn cam
clockwise 1 increment at a time until doors are
aligned. Open and close doors. Tighten hinge
screws.
U /
A. Rear roller adjustment screw
B. Door hinge screws
C. Hinge adjusting cam
D. Front rolleradjustment screw
Review "Installation Checklist" in
Owner's Manual with consumer.
.
A. "P"clamp B. Coppertubing
C. Brass nut D. Brass sleeve
E. Water valve inlet connection
Turn on water supply to refrigerator and check for
leaks. Correct any leaks.
Loading ...
Loading ...
Loading ...