Loading ...
Loading ...
Loading ...
-12-
Operating Tips
You will extend the life of your bits and do
neater work if you always put the bit in contact
with the work before pulling the trigger. During
the oper a tion, hold the tool firmly and exert
light, steady pressure. Too much pressure at
low speed will stall the tool. This can be
damaging to both tool and bit.
DRIVING WITH VARIABLE SPEED
The technique is to start slowly, increasing the
speed as the screw runs down. Set the screw
snug ly by slowing to a stop. Prior to driving
screws, pilot and clearance holes should be
drilled.
Always hold the machine straight on the bolt to
be tightened.
The best method to determine the right
impacting/tightening duration is by means of a
trial. For small screws, the right
impacting/tightening duration can be reached
in less then 0.5 Sec. Therefore, work with low
RPM and switch the machine off immediately
when the screw is tight and the impacting
sound can be heard.
For screwing larger, longer wood screws into
hard material, pre-drilling is the best method.
TIGHTENING TORQUE
The tightening torque depends on the duration
of the impacting/tightening action. The largest
tightening torque is achieved after approx. 6 to
10 Sec. impacting/tightening action.
The torque build-up depends on the
following factors:
• Hardness of the bolts/nuts.
• Type of washer (disk washer, spring washer,
seal).
• Hardness of the material to be joined.
• Lubricating effect at the surfaces of the
junction.
This leads to the following application cases:
Hard case: The joining of metal to metal with a
disk washer. The maximum torque is reached
after a relative short impacting/tightening
action.
Medium case: The joining of metal to metal
where spring ring washer, disk spring washer,
stud bolts or bolts/nuts with conical seats are
used.
Soft case: The joining of e.g. metal to wood or
insulation material.
For middle or soft joining cases, the maximum
tightening torque is less as for hard cases.
Therefore, a longer impacting/tightening action
is necessary to arrive at the maximum
tightening torque.
INSERTING AND RELEASING
BATTERY PACK
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 6).
Y
our tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 6).
FIG. 6
2610051971.qxp_GDR18V-1400 GDX18V1600 2/11/19 9:07 AM Page 12
Loading ...
Loading ...
Loading ...