Loading ...
Loading ...
Loading ...
29
Operation
28
Operation
Operating the Dishwasher Operating the Dishwasher
Filling Rinse Agent Dispenser
WARNING
Keep your rinse agents out of the reach of children. Ingestion or inhalation
of rinse agent may cause serious injury. Avoid contact with skin and eyes,
and keep children and people in poor health away from rinse agents.
NOTICE
• Only use rinse agents suitable for use in dishwashers. Rinse aids allow
washing water to rinse off more cleanly and prevent watermarks or
streaks on the dishes.
• If you use “2 in 1” or “3 in 1” detergents/tabs, you do not need
additional rinse agent.
• Open the rinse agent dispenser by
pressing the lock B.
• Carefully pour in rinse agent to the MAX
mark.
• Close the lid until it clicks in 3.
• Carefully wipe off spilled rinse agent.
Excessive rinse agent causes excessive
foam formation, which may hinder
cleaning.
Set the Dose of Rinse Agent
The dose of rinse agent to be used can
be set by means of the dispenser
regulator 4 between levels 1 and 6.
Change the setting, only if the following
applies after washing:
• Watermarks are visible on the dishes: Set
dosage higher.
• Streaks are visible on the dishes: Set dosage lower.
Setting the Water Softener (select models)
• Press the Program Selection button before you switch the appliance
on and keep this button pressed down.
• Switch the appliance on using the On/Off button; then release the
switch.
• Release the Program Selection button when the water hardness
level stored on your machine is displayed in “r.....” format.
• Start/Stop icon will start flashing as soon as the water hardness level
store on your machine.
• Water hardness can be set to the desired level by pressing the Time
Delay button (compare the test strip with the degrees of Hardness
Table). The appropriate program lights up.
• Once you have set the hardness level, press the Start/Stop/Cancel
button to save the value. The control indicator on the
Start/Stop/Cancel button now lights up permanently.
• Switch the appliance off again using the On/Off button.
Loading ...
Loading ...
Loading ...