Loading ...
Loading ...
Loading ...
04 05
Connect the juicer to the body:
1. Align the center position of the feeding port of the juicer body with the
alignment "unlock mark" on the body and put it into the body (the three
buckles of the juicer body will be aligned).
2. Then turn it counterclockwise, when you hear a "click" sound, it means
the connection is in place.
Align the hardware shaft of the screw propeller with the motor shaft on the
body, and push it until the bottom. (When misaligned, it can be easily aligned
by turning the auger slightly)
Insert the large hole of the juice net from the tail of the screw propeller, and
push the positioning ribs of the juice net into the notch in the juice extractor.
Stagger the three buckles on the juicer body cover and the three buckles on
the juicer body, push them in, and then rotate counterclockwise to tighten the
juicer body cover and the juicer body.
1
2
3
4
Button switch operation instructions:
ON/OFFkey : use the key for normal work, and it is also the key to close and
stop
"Reverse" key: when the slag discharge is not smooth or the rotor is blocked,
the key is used. (Tip: When the slag discharge is not smooth or the rotor is
blocked, press the "Reverse" button, the screw propeller will start to reverse,
and the motor will automatically stop reversing after 10 seconds of reverse
rotation; Then resume the forward rotation and continue to work.
Loading ...
Loading ...
Loading ...