Loading ...
Loading ...
Loading ...
10 | Page
3. To reattach the Toe-Kick, slide over the left and right
mounting brackets, such that bottom tabs of the Toe-
Kick rest on top of the bracket bases. This will allow
the Toe-Kick and mounting bracket screw holes to
align.
4. If the black Toe-Kick alone is desired, reinsert the
two front screws through the Toe-Kick screw holes and
into the mounting brackets. Gently tighten with a
Philips screwdriver. Take care not to over-tighten the
screws.
If the stainless steel appearance is desired, then place
the stainless steel applique over the Toe-Kick and align
the applique holes with the Toe-Kick holes before
reinserting and tightening the screws.
Cleaning the appliance
WARNING:
Never clean the appliance with a steam cleaner!
CAUTION:
• Do not use abrasive or acidic cleaning agents and
solvents.
• Do not use scouring or abrasive sponges. The
metallic surfaces could corrode.
• Never clean the wine racks in the dishwasher. The
parts may be damaged.
Proceed as follows:
1. Before cleaning: switch the appliance off. For
instructions, see “Off Mode” section on the “Special
Functions” page.
2. Clean the appliance, and the wine racks with a soft
cloth, lukewarm water and a little pH neutral detergent.
CAUTION:
When rinsing the cabinet, water must not enter the
interior light recess located on the upper side of the
interior cabinet, or spill out from the bottom of the
cabinet.
3. Wipe the door seals with clear water only and then
wipe dry thoroughly.
4. Switch the appliance back on.
Cleaning behind the Toe-Kick
1. Before cleaning: switch the appliance off.
2. Remove the Toe-Kick. See “Toe-Kick & Stainless
applique” section on the previous page.
WARNING:
Do not remove the electrical box cover behind the
Toe-Kick. Risk of electric shock!
3. Use a vacuum cleaner with an extended attachment
to clean the accessible areas when they are dusty or
dirty.
4. Replace the Toe-Kick.
5. Switch the appliance on.
Bottom tabs
Bracket bases
Front screws
Loading ...
Loading ...
Loading ...