#6-0440 SNAPPERIZER KIT for SNAPPER 21" STEEL DECK MOWERS
This kit will convert your SNAPPER 21" mower into
an effective pulverizer of leaves, pine straw, light
twigs and similar lawn debris. The Snapperlzer is
intended primarily for use with grass catcher
equipped mowers to vacuum and bag the pulverized
material but can also be used with side discharge
mowers to broadcast materials back onto the lawn.
INSTALLING THE SNAPPERIZER
1: Position the screen on underside and turn it until
the three studs on the screen go through the
matching holes in deck then secure with three split
IoclaNashers and hex nuts on topside of deck.
(See Figure 1).
RECOMMENDED USE: Install the Snapperizer for
Spring and Fall clean-ups but remove it dudng the
regular grass cutting season. The mower will cut
grass with the Snappedzer if no more than 1/2" is
being cut off the top, however, heavy and/or wet
clippings will quickly clog the Snapperizer screen.
Use the Snapperizer under the driest possible
conditions for best results. Your mower will do a
great job of vacuuming ddveways and walks with
only the bottom plate of the kit Installed.
UNDERSIDE VIEW OF DECK
@
DISCHARGE
OPENIN_
PREPARING THE MOWER FOR SNAPPERIZER
WARNING: Always disconnect the spark plug wire
and secure the end away from the plug before in.
spectlng/servtcing the blade, to prevent uninten-|
tional start-ups.
FRONT OF MOWER
1: Disconnect the spark plug wire an secure it away
from the plug to prevent unintentional starting.
2: Empty the fuel tank or tape vent in fuel filler cap
closed to prevent leakage.
Fig. 1 - Screen Mounting Holes
2: Reinstall the cutting blade, position widest pert of
cone washer next to the blade then reinstall the
rstalnlng screw and tighten to 30 foot pounds
torque. (See Figure 2).
3: Tilt the mower back on it's handles and block
deck in raised position to allow working on the
underside of the deck.
BE CAREFUL: AVOID CUTTING YOURSELF ON A
SHARP BLADE! Wear gloves to protect your hands
,while handling the blade.
4: Block cutting blade to prevent it's turning then
remove the blade. Save blade and hardware - these
items will be reinstalled after the screen is in
position.
5: Use a metal scraper and wire brush to remove dirt
and grass clippings from the underside of the deck
to allow proper fitting of the Snappedzer screen.
Fig. 2 - Blade Installed After Screen
INSTRUCTION #%3679 Page 1 (over)
Loading ...
