Loading ...
Loading ...
Loading ...
CONTROL PURPOSE COMMENTS
" To start or resume a if the door is opened during a CYcle or the power is interrupted, the START/RESUME
[] indicator flashes. The cycle will not resume until the door is closed and START/RESUME is
pressed.
NOTE" If the START/RESUME button is located ont0P of door, push door firmly closed
Within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
the start button LED wil! flash, an audible tone wi!! be heard, and the cycle wi!! not start,
[]
Icancel I
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing A Cycle After Dishwasher Is Started" sections.
To turn the audible Press and h01d theHi Temp Wash button for 3 seconds to tuin the aUdibie tones on 0roff.
CONTROL PURPOSE COMMENTS
m wash m dry mdoan m sanitiTed
The Cycle Status Indicator Clean indicator glows when a cycle is finished.
Lights are used to follow the If you select the Sani Rinse option, when the Sani Rinse cycle is finished,
progress of the dishwasher the Sanitized indicator glows. If your dishwasher did not properly sanitize
cycle. Located on the front your dishes, the light flashes at the end of the cycle. This can happen if the
of the dishwasher for front cycle is interrupted, or the water could not be heated to the required
control models, and located temperature.
on the top of the door for
hidden control models. The Clean and Sanitized lights go off when youopen and close the door or
press CANCEL.
Canceling A Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press CANCEL!DRAIN button once. The Cancel/Drain light will
light up.
3. Close the door and the dishwasher starts a drain cycle (if water
remains in bottom of dishwasher). Let the dishwasher drain
completely. The Cancel/Drain light turns off after 2 minutes.
Changing A Cycle After Dishwasher Is Started
1. You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting your new cycle.
4. Press CANCEL!DRAIN twice to reset the control.
5. Select new cycles and options.
6. Press START/RESUME.
Adding A Dish After Dishwasher Is Started
1. Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5. Press START/RESUME.
Loading ...
Loading ...
Loading ...