Loading ...
Loading ...
Loading ...
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Wrenches
(2) 1/2" Wrench
(1) Pliers
(1) Hammer
STEP 3: (SEE FIGURE 3)
• Install a compression spring (27) into the bottom of
each of the pivot rod retainers, securing them to the
bag arm channels.
STEP 1: (SEE FIGURE 1)
Secure each bag arm channel (6) to the sweeper
housing using two 3/8" x 2-1/4" clevis pins (23) and
two small hairpin cotters (19).
FIGURE 3
FIGURE 1
STEP 2: (SEE FIGURE 2)
Place a pivot rod support bracket (28) in the end of a
bag arm channel and then insert a pivot rod retainer
(26) down into the slots in the bracket and the
channel. Repeat for the other bag arm channel.
28
STEP 4: (SEE FIGURE4)
Attach the drawbar brackets (4) to the drawbar (3)
using one 5/16" x 2-1/2" hex bolt (15), two washers
(59), and one 5/16" nylock nut (21). Make the nut
finger tight only.
Insert the 3/8" x 3" pin (16) into the brackets and
drawbar and install a small hairpin cotter (19).
FIGURE 4
FIGURE 2
5
Loading ...
Loading ...
Loading ...