Loading ...
Loading ...
Loading ...
Installation
English24
Installation
STEP 5 Power on
Plug the power cord into an AC 120 V / 60 Hz approved electrical outlet protected by a
15-amp fuse or circuit breaker. Then, press
Power to turn on the washer.
STEP 6 Run a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 lb. of laundry into the tub.
2. Press Power to turn on your washer.
3. Turn the Cycle Selector to RINSE+SPIN.
4. Press and hold Start/Pause (Hold to Start) to start the test cycle.
5. The washer should not rock or vibrate excessively during water supply, washing,
spinning, and water should drain well during spinning process.
NOTE
• If water leaks while water is being supplied or drained, check the water connections.
See the “STEP 2 Connect the water hose” section on page 19.
• If the washer rocks and vibrates excessively, level your washer again. See the “STEP 4
Level the washer” section on page 22.
Untitled-5 24 2019-01-22 11:33:10
Loading ...
Loading ...
Loading ...