Loading ...
Loading ...
Loading ...
Installation Instructions Models 20, 22, 25
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
–
Save these instructions for
local inspector’s use.
•
IMPORTANT
–
Observe all governing
codes and ordinances.
• Note to Installer
–
Be sure to leave these
instructions with the Consumer.
• Note to Consumer
–
Keep these instructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of installer.
• Product failure due to improper installation is not
covered under the Warranty.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature will
go below 60°F (16°C) because it will not run often enough
to maintain proper temperatures.
•
Do not install the refrigerator where the temperature will
go above 100°F (37°C) because it will not perform properly.
• Do not install the refrigerator in a location exposed to water
(rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully loaded.
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8Ý (4 mm) • Top 1Ý (25 mm) • Back 1Ý (25 mm)
A door clearance of 3/4Ý (19 mm) is needed for a 90º door
opening which provides better access to food storage area.
CLEARANCES
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE Appliances water
supply kit is available at extra cost from your dealer, by
visiting our Website at GEAppliances.com (in Canada, at
GEAppliances.ca), or from Parts and Accessories,
877.959.8688.
WATER SUPPLY TO THE ICEMAKER (on
some models)
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
Questions? In Canada, call 1.800.561.3344 or Visit our Website at: geappliances.ca
The rollers have 3 purposes:
Rollers adjust so the door closes easily when opened
about halfway.
Rollers adjust so the refrigerator is firmly positioned on
the floor and does not wobble.
Rollers allow you to move the refrigerator away from the
wall for cleaning.
To adjust the rollers, remove the
base grille by pulling it out at the
bottom.
Turn the roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Use an adjustable
wrench (3/8ļ hex head bolt) or
pliers.
To replace base grille, line up the
clips on back of grille between
the bar and the bottom of the
cabinet. Push forward until grille
snaps into place.
ROLLERS
12
To remove the
base grille, open
the doors and
then pull the
grille straight out.
Ý6RFNHW
Wrench
Raise
DOOR ALIGNMENT
After leveling, make sure that doors are even at the top.
To make the doors even, adjust the refrigerator door.
8VLQJDÝVRFNHWZUHQFKWXUQWKHGRRUDGMXVWLQJ
screw to the right to raise the door, to the left to lower
it. (A nylon plug, embedded in the threads of the pin,
prevents the pin from turning unless a wrench is used.)
After one or two turns of the wrench, open and close the
refrigerator compartment door and check the alignment
at the top of the doors.
Loading ...
Loading ...
Loading ...