Loading ...
Loading ...
Loading ...
8
newair.com
ASSEMBLY & INSTALLATION
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• Before connecting this appliance to the power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR APPLIANCE
• The appliance is designed for free-standing installation only.
• WARNING: Do not store or install the appliance outdoors.
• CAUTION: This appliance is designed for storing and cooling beverages and
drinks. Do not store perishable food, medicine or other medical products.
• Place your Wine Cooler on a floor that is strong enough to support it when
it is fully loaded. To level the unit, adjust the front leveling legs.
• For free-standing installation, leave 5 inches (127mm) of space around the
back and sides of the unit to allow proper air circulation to cool the
compressor and condenser.
• NOTE: It is recommended that you do not install the appliance near an
oven, radiator or other heating source. Direct sunlight may affect the
acrylic coating and heat sources may increase electrical consumption.
Don’t install in a location where the temperature will fall below 64°F
(18°C). For best performance, do not install the appliance behind a cabinet
door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the Wine Cooler into an exclusive, properly grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should
be directed toward a certified electrician or an authorized service center.
Loading ...
Loading ...
Loading ...