Loading ...
Loading ...
Loading ...
9
Panel Installation Instructions for the Drawer Fronts
NOTE: Some units are designed to be panel ready
(PNR). Please check
www.summitappliance.com if you are unsure if
you have a PNR unit.
These models are designed for field-installed overlay
panels. The overlay panels cover the stainless steel to
give a built-in appearance. The overlay panel and
appropriate hardware are not included with the unit and
the end user needs to prepare them himself. Please
follow the instructions below for installation:
1. Remove any items stored inside the drawers. Press
the left slide release lever down and at the same
time lift the corresponding right slide lever up, and
pull the drawer out until it is free of tracks and the
cabinet. (Fig. 1)
2. Peel off the gasket and remove the handle by
removing the two screws that attach the handle to
the door.
3. Drill the 2 holes shown by using a 3/16” drill bit on
the bottom of drawer door front. (Fig. 2)
4. Cut the overlay panels with thickness 3/4” to the
following dimensions: 23.43” x 15”.
5. If reusing the handles that came with the unit, drill
two holes with diameter 3/16”in the overlay panel.
Attach the handle and overlay panel together to the
drawer face using 2 M4x65 screws and through the
upper 2 existing holes inside the door groove. Then
attach the overlay panel to the drawer face using 2
wood screws #10x2 (ST4x50) Type AB Phillips and
through the lower 2 existing holes inside the door
groove. (Fig. 3)
6. If user-supplied handles will be used, attach the
handles to the overlay panels by using the flat head
screws and drive the screws flush with the panels.
Then attach the overlay panel to the drawer face
using the 4 wood screws #10x2 (ST4x50) and
through the 4 existing holes inside the door groove.
7. Peel back the gaskets, then align the left and right
slide channels with the tracks in the cabinet.
Ensuring an even track engagement on both sides,
gently push the drawer into the cabinet until it
stops.
Loading ...
Loading ...
Loading ...