Loading ...
Loading ...
Loading ...
Oven Light
The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here. Ifyou need further assistance or more recommendations that may help you avoid aservice call, refer
to the warranty page in this manual and scan the code there with your mobile device, or visit http.//www.whirlpool.com/product help.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Operation
PROBLEM POSSIBLE CAUSES SOLUTIONS
Nothing will operate Power supply cord is unplugged. Plug into a grounded outlet.
ENERGY SAVE is active, and the Press any key on the control to display the Time of Day. See the
display is blank. "Electronic Oven Controls" section for more information.
Household fuse is blown, or a circuit Replace the fuse or reset the circuit breaker. If the problem
breaker is tripped, continues, call an electrician.
The control displays an F9 or F9 E0 The electrical outlet in the home may be miswired. Contact a
error code. qualified electrician to verify the electrical supply.
Cooktop will not operate The control knob is not set correctly. Push in knob before turning to a setting.
On ceramic glass models, the oven See the control lock keypad feature in the "Feature Guide."
control lockout is set.
Excessive heat around Cookware is not the proper size. Use cookware about the same size as the surface cooking
cookware on cooktop area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Cooktop cooking results Control knob set to incorrect heat See "Cooktop Use" section.
not what expected level.
Range is not level. Level the range. See the Installation Instructions.
Cooktop element cycles Element cycling due to a temperature This is normal operation. The element may cycle on and off to
on and off on High setting, limiter, keep the cooktop from overheating.
Oven will not operate Delay start is set. See "Cook Time" section.
Control lock is on. Press and hold START for 3 seconds to unlock.
Control is in Demo Mode. Press and hold START TIME for 10 seconds to exit Demo
Mode. Demo Mode is used for display models in a showroom.
Electronic oven control set incorrectly. See "Electronic Oven Controls" section.
Oven temperature too Oven temperature needs adjustment. See "Oven Temperature Control" in the "Electronic Oven
high or too low Controls" section.
Oven indicator lights flash Power to range is turned on or See "Control Display" in the "Electronic Oven Controls"
restored, section. If the indicator lights keep flashing, call for service. See
cover for contact information.
Display shows messages Power failure (display shows flashing Clear the display. On some models, reset the clock, if needed.
time). See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter Depending on your model, press CANCEL to clear the display.
followed by number). See "Control Display" in the "Electronic Oven Controls"
section. If it reappears, call for service. See cover for contact
information.
Start needs to be pressed so a cycle See the "Start" keypad feature in the "Feature Guide" section.
can begin (display shows "PUSH" or
"PSH").
14
Loading ...
Loading ...