GE - General Electric TBH14SR Legacy

User Manual - Page 11

For TBH14SR.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Refrigerator Location
Clearances
Do not install refrigerator where
Do install it on a floor strong Allow the following clearances for
temperature will go below 60°F. enough to support a fully loaded ease of installation and proper air
because it will not run often
refrigerator.
circulation.
enough to maintain proper
The location of your refrigerator is Sides
.................................3/4”
temperatures.
important. Avoid locating it next to
Top. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1“
a range, a heating vent or where the
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1“
sun will shine directly on it.
Rollers and Leveling Legs
Leveling legs near each front
corner of the refrigerator are
adjustable. They firmly position
the refrigerator and prevent it from
moving when the doors are opened.
Leveling legs should be set so the
front of the refrigerator is raised
iust
enough
that the doors close
o
d
K-
Rollers
next
to
the leveling legs
allow you to move the refrigerator
\
away from the wall for cleaning.
.
c-
Turn the legs counterclockwise until
the weight of the refrigerator is
transferred from them to the rollers.
After rolling the refrigerator back
~asily
wh~n
opened about halfway.
Turn the leveling legs clockwise
into place, turn the legs clockwise
until the lem
again
bear the
weight
to raise
the refrigerator,
of
the
refri~era~or.
counterclockwise to lower it.
Water Supply to Icemaker
(on some models)
If your refrigerator has an icemaker, or if you plan to add an icemaker later,
the icemaker will have to be connected to a cold water line. There should be
sufficient tubing for the icemaker from the cold water supply to allow
moving the refrigerator out from the wall several feet (approximately
8
feet
of 1/4” copper tubing in three 10-inch diameter coils). A water supply kit is
available at extra cost from your GE dealer.
Preparing to Move
Disconnect the power cord from the wall outlet,
remove all food and clean and dry the interior.
Secure all loose items such as grille, shelves, storage
drawers and ice trays by taping them securely in place
to prevent damage, and raise the leveling legs.
Be sure the refrigerator stays in an upright position
during actual moving and in the van. The refrigerator
must be secured in the van to prevent movement.
Protect the outside of the refrigerator with a blanket.
Preparing for Vacation
For extended vacations or absences, shut off power
to the refrigerator, turn the temperature control to the
OFF position, and clean the interior with baking soda
solution of one tablespoon of baking soda to one quart
of water. Wipe dry. To prevent odors, leave an open
box of baking soda in refrigerator.
Lea\’e
the doors open.
For shorter vacations, remove perishable foods and
leave the controls at regular settings. However, if
room temperature is expected to drop below
60”F.,
follow same instructions as for extended vacations.
If you have an icemaker, set it to the STOP position and
be sure to shut off the water supply to the refrigerator.
11
1
.—
Loading ...
Loading ...
Loading ...