Loading ...
Loading ...
Loading ...
INITIAL INSTALLATION
7
DOWNROD-STYLE FAN MOUNTING
Open End
C
C
Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is installed
facing the higher point of the ceiling, and ensure
the ceiling angle is not steeper than 19°.
Remove pin (N) and clip (O) from downrod (A).
Partially loosen preassembled set screws and
nuts in yoke at top of motor housing (D).
1a.
1b.
ANGLE
MOUNT
STANDARD
MOUNT
5.
5
D
1b
Yoke
Set Screw
& Nut
Sideview
1a
O
N
A
6.
6
D
Motor
Block
R
Remove preassembled motor blocks from
underside of motor housing (D). Discard the
motor blocks.
Remove motor screws/washers (R) from
underside of motor housing (D), and save for
blade arm (L) attachment later on.
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 9.
Loading ...
Loading ...
Loading ...