Loading ...
Loading ...
Loading ...
Section 4 - ADJUSTMENTS & REPAIR
WARNING A I
Before attempting any adjustments or repairs, STOP I
the engine, remove the spark plug wire from the I
spark plug and secure wire away from plug. I
4.3.3. DRIVEN DISC ADJUSTMENT
(Continued From Previous Page)
2. Remove driven disc spring from driven disc
assembly. Loosen connector hex nut. See Figure 4.9.
DRIVEN DISC ASSEMBLY
DRIVE
DISC
DRIVEN
DISC
SPRING
TRANSFER
ROD
SLIDE DRIVEN
DISC ASSEMBLY
TOWARD
OUTSIDE EDGE
1/8" MEASUREMENT TO
OUTSIDE EDGE OF
91" DRIVE DISC
DRIVE
.CONNECTOR ' EDGE
FIGURE 4.10
CONNECTOR
HEX NUT
FIGURE 4.9
3. Slide driven disc assembly over to 1/8" from outside
edge of drive disc. Maintaining the 1/8" measurement,
remove any looseness from the linkage. This can be
done by holding the transfer rod and applying pressure
to the left (as viewed from operators position). Then
retighten the connector hex nut securely. See Figure
4.10. Move ground speed control to the first speed
position, then back to the sixth speed position.
Recheck the 1/8" measurement described previously.
Reinstall driven disc spring to driven disc assembly.
4.3.4. Replacing Rubber Driven Disc Ring
(Commercial Model)
If the rubber ring is badly chunked or worn down to
within 1/16" of the metal rim of the driven disc hub, it
must be replaced. Install new rubber ring as follows:
1. Using a small flat blade screwdriver, free the clip
from the transfer rod. Then remove the transfer rod
from the clip and the speed control rod. See Figure
4.11.
CONNECTOR
SPEED CONTROL
ROD
FIGURE 4.11
14
Loading ...
Loading ...
Loading ...