Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
42
Information on the display panel
Display Cause/remedy
Re-fill the
i-DOS i I w ,
w dispenser
The i-DOS dispensers are below the minimum fill level; top up ~ Page 32.
i-DOS i I w, i-DOS
w error;
deactivate
i-DOS i I w, i-DOS w
set i-DOS i I w , i-DOS w to off.
Call the after-sales service. The appliance can still be operated using manual
dosing. Manual dosing ~ Page 35
Please close
detergent drawer
Push the detergent drawer in correctly. ~ Page 33
Pause: Reload is not
possible
Water level or temperature is too high. Press the A button to continue the
programme.
Door cannot be
unlocked: Water level
or temperature is too
high
Water level or temperature is too high. Press the A button to continue the
programme.
The door cannot be
locked; please open
the door again, then
close it and select the
A button
Laundry may be caught. Open and close the door again and press the A
button.
If necessary, push the door closed or remove some laundry and then push it
closed again.
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Please open tap Turn on the tap fully,
Supply hose kinked/trapped,
The water pressure is too low. Clean the filter. ~ Page 41
Please clean pump The drain pump is blocked. Clean the drain pump. ~ Page 40
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 40
AquaStop has been
activated! Please call
the after-sales service
Does not occur for models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
Auto power-off in ...
seconds
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button. ~ Page 36
Water cooling To protect the wastewater pipes, the hot detergent solution is cooled before being
drained.
Loading ...
Loading ...
Loading ...