Loading ...
Loading ...
Loading ...
CLEANING AND CARE
CHARCOALFI_ERS
Charcoal Filters, which are attached with Hood
Louver, are used for nonvented, recirculated instal-
lation. The filter should be changed every 6 to 12
months depending on use.
1. Disconnect power to the microwave oven at the
circuit breaker panel or by unplugging.
2. Remove three Houver Louver Screws.
3. Push the upper tabs and pull the louver away
from the unit.
4. Remove the charcoal filters from hood louver and
replace new charcoal filters by piercing tabs into
the holes in charcoal filters.
5. Carefully push the louver back into place and
replace the screws removed at step 2.
Oven Light Cover
Figure 1
Hood Louver
Upper Tab
Inside of Hood Louver
Tabs
Figure 2
MICROWAVE OVEN LIGHT
Remove the louver per
used.
instructions 1-3 above, if
1. To replace krypton light bulb, first disconnect
power to the microwave oven at the circuit
breaker panel or by unplugging.
2. Open oven light cover by carefully pulling up on
the front edge. See figure 1.
3. Remove light bulb and replace 40 watts krypton
light bulb. DO NOT USE BULB LARGER THAN
40 WATTS.
.
Close the Oven Light Cover by carefully push-
ing into place. Push the louver back into place
(engaging both the bottom and top tabs) and
replace three Houver Louver Screws.
VENT HOOD LIGHT BULBS
1. To replace krypton light bulb, first disconnect
power to the microwave oven at the circuit
breaker panel or by unplugging.
2. To open Light Cover, remove the screw on the
light cover. (See Figure 3.)
3. Replace the 40 watts krypton light bulb with new
one. DO NOT USE A BULB LARGER THAN 40
WATTS.
.
Close the Light Cover and secure with screw
removed at step 2.
BOTTOM VIEW
Light Bulb (Front of microwave oven)
//' ,,,
Figure 3
........ _ (Rear of microwave oven)
Light Cover Screw
Loading ...
Loading ...
Loading ...