Loading ...
Loading ...
Loading ...
10 BISSELL.com
Cleaning & Replacing the Filters
Go to support.BISSELL.com for tips on maintaining and replacing your vacuum filters.
1. Turn OFF machine and
remove dirt tank from the
hand vacuum.
2. Pull filter from the top of
the tank. Remove the filter
from the filter frame housing.
Tap the filter against the side
of a trash bin to remove dust
and debris.
3. Rinse under warm water
and squeeze to remove dirt.
Lay out for 24 hours, until
completely dry. Replace
filter into the frame with the
tag side down (touching the
frame) before use.
1. Turn OFF machine and press
the latch on the back of the
hand vacuum.
2. Remove the post-motor
filter from the vacuum.
3. If there’s debris on the filter,
tap it on a trash bin and rinse
under warm water. Let dry
for at least 24 hours before
putting it back in the vacuum
and replacing the filter cover.
Pre-Motor Filters
For best cleaning performance, always clean your pre-motor filter after each use.
Post-Motor Filter
WARNING
» Do not use your vacuum until you are familiar with all instructions and operating procedures.
» Before using your vacuum, make sure that the dirt tank is in locked position and that all filters, both pre- and post-motor filters,
are in place. DO NOT operate your vacuum without these filters.
Loading ...
Loading ...