Loading ...
Loading ...
Loading ...
DISHWASHER PREPARATION
(continued}
Removing the Toe Panel
Regular Toe Panel
The toe paneHis HooseHyattached with tape, Remove
the tape and puHHthe toe paneHaway from the dish=
washer, Set the toe paneHaside, HtwHHbe reinstaHHed
Hater,
hstaHing the 90 ° E_bow Fitting
NOTE: The 90 ° eHbowfitting is not supplied with the
dishwasher, and must be purchased separateHy (see
MateriaHs Needed section), Hfthe dishwasher's hot
water suppHy Hne is to be copper tubing, make certain
the eHbowhas a compression fitting,
AppHyTeflon tape or other pipe seaHant when required,
Orient the hot water suppHyconnection Hegof the
eHbowtoward the channeH opening in the dishwasher
base,
NOTE: The white hose on the dishwasher's right side
paneHis a factory-instaHHedvent hose, not to be
confused with the gray drain hose, The vent hose
requires neither repositioning nor connecting by the
consumer,
Junction Box Preparation
1) Remove the junction box cover by removing the
screw on the Heftside of the junction box, as shown in
Figure 12, HetterA, and HiRingthe junction box cover up
and off,
2) Remove the strain reHiefpilate by removing the
screw at the back of the junction box, as shown in
Figure 13, HetterB and sHiding the strain reHiefpilate
out,
3) Set the junction box cover, strain reHiefpilate, and
screws aside, They wiHHbe re-instaHHedHater,
Figure 12
Figure 13
J
8 Dishwasher Preparation
Loading ...
Loading ...
Loading ...