Loading ...
Loading ...
Loading ...
www.adj.com
13
RECEIVE (DMX CONTROL) MODE
5. Set each Channel to Switch or Dimmer mode by pressing the MENU button to select the desired
channel (C1, C2, C3, C4) Then press the UP or DOWN buttons to select
SS
for Switch or
dd
for Dimmer.
(see images below)
LED Display Showing Channel 1 in Switch Mode
LED Display Showing Channel 1 in Dimmer Mode
6. Press the MENU button until the DMX address shows on the LED display. (see LED image below)
7. Connect a 3pin XLR cable (not included) from the DMX controller to the DMX IN and connect a 3pin
XLR cable (not included) from the DMX OUT port on the pack to the next DMX device if used.
8. Connect lighting devices to the any of the 4 sets of channel sockets on the pack.
* * * DO NOT EXCEED MAX 15A / 1,800W Total per unit | 5A / 600W Total per any channel * * *
9. Pack channels can now be controlled via DMX and each channel will function either as a switch
(on/off) or as a dimmer (0-100%) according to the mode they were set to in step 5 above.
C1-S
C1-d
A:001
Loading ...
Loading ...
Loading ...