Loading ...
Loading ...
Loading ...
Page 4 Protimeter Surveymaster
6 Search Mode (REL)
When used in Search mode (REL), the Surveymaster is a
moisture detector. Search mode readings give, in relative terms,
the moisture condition up to 19mm / 3/4” beneath the surface of
materials. This mode of operation is ideal for making rapid
surveys of solid walls and floors and to pinpoint areas of
concern that may justify a more extensive investigation. The
Search mode may also be used as an alternative to the Measure
mode when it is impractical or undesirable to push electrode
pins into surfaces. Consider, for example, taking moisture
readings behind ceramic tiles in shower cubicles or in walls
covered by quality wallpapers where pinholes would not be
acceptable. Surface moisture (such as condensation on an
otherwise dry wall) has little effect on Search mode readings.
Conductors (other than water) within the material may cause
high Search mode readings. Make sure the flat surface on the
back of the meter is in full contact with the material to be tested.
It is recommended that users place the meter onto different areas
to measure and do not slide the meter across surfaces.
Note: Sliding the meter can cause premature wear to the back of
the meter.
7 Reference Mode
In both Pin and Search mode, Protimeter's patent pending
Reference Mode can be used. Measure the material until the
meter’s reading is stable then press for 2 seconds. This will
store the reading until the mode changes of the meter turns off.
Now all reading taken after will be displayed as normal, but
below you will see a second reading that shows you if the
material is measured above or below the original reading.
Reference mode can be useful when trying to establish what
materials are above or below a point of reference or dry
standard. See page 6 for further information.
Loading ...
Loading ...
Loading ...