Loading ...
Loading ...
Loading ...
• Attach the left rear wheel to the edger/
trimmer shown in figure below with a
3/8-16 x 1.40 inch Shoulder bolt, spacer
and 3/8-16 hex head whiz lock nut found
in parts bag and tighten nut.
VIEW FROM INSIDE LEFT REAR WHEEL
Spacer
(.70 inchlong)
Shouk_erBolt
3/8-16xl .40
3/8-16
Whiz-lock Nut
• Attach the front wheels to the Edger/
Trimmer shown in figure below with a
5/16-18 x 4.50 inch hex head screw, four
11/32 x 11/16 inch flatwashers, two
spacers and a 5/16-18 hex head wide
flange locknut found in parts bag.
VIEW FROM FRONT
._--. ,. Flatwasher
11/32xt 1/16
control rod through the hole in the quill
support arm. Attach with hairpin found in
parts bag.
• Move the clutch lever to rearmost
NEUTRAL position and latch in.
• If it is difficult to get the clutch lever into
NEUTRAL, it may be necessary to loosen
the four screws and nuts holding the
lower handles to the frame as shown in
first figure on page 7. Pry up (forward) on
the handles only enough to allow the
clutch lever to freely enter the NEUTRAL
position. Re-tightan nuts and screws.
When the clutch lever is in NEUTRAL the
quill support arm should be close to the
spacer and screw behind itas shown
in last figure on this page•
'_ _ Rod
_1_First_epth-_
_Selection I_ Quill
Handle Panel
11/32xl
Hex Head Screw
5/16-18 Wide
Flange Locknut
Inch Long)
• Place the handle panel on the inside of
lower handle. Hold in place while placing
the upper handle on the lower handle as
shown in next figure. Align holes in upper
handle, lower handle and handle panel,
secure in place with four 5/16-18 x
1-5/8 inch carriage bolts and four
5/16-18 hex head Iocknuts found in parts
bag. Locknuts should be to the inside of
the handle panel as shown.
• The clutch lever is located on the left
hand side of upper handle when properly
installed. Insert one end of the control rod
from left to right through the hole in the
clutch lever and attach with a hair pin
found in parts bags. See figure.
* Place the clutch_lever in the first depth
selection and insert the other end of the
6
5/16-18xl-5/8
5/16-18 Hex
Head Lock,nut
Handle
Loading ...
Loading ...
Loading ...