Loading ...
Loading ...
Loading ...
- 10 -
1. FIXING THE HOOD TO THE LOWER PART OF THE WALL CABINET:
Follow the steps below:
1- Position template B on the wall unit, bearing in mind the measurements indicated in
g. 1-2 and the minimum distance from the hob.
- Mark the references to x brackets A to the wall unit, as indicated in gure 4.
2- Make sure the thickness of the wall unit is within the parameters indicated in gure
4 - step 2.
3- Build the hood in the wall unit and make sure the 2 side springs F are connected cor-
rectly. Fasten the hood to the wall unit using the screwdriver and the relative screws M
and tighten until the device is rmly against the wall unit (gure 4 - step 2).
4- Remove pin Y from bracket A. Then place the insert X on the slot of the bracket A, as
indicated in gure 4 - step 3.
- Match the C screws with the L wascher and x the A bracket to the cabinet as indicated
in gure 4 - step 3.1. Pay attention not to completely tighten screws C before the bracket
Loading ...
Loading ...
Loading ...