Loading ...
Loading ...
Loading ...
8
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote Troubleshooting
Installing the Glass
Lift the cover and align the
notches in the cover with the
two short light kit screws.
NOTE: Check to ensure
proper engagement.
Attach the cover by engaging light
kit screws and turning clockwise
one third of a full turn of the cover
until it stops.
Notch
Short Screws
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the LIght Kit
Insert the third screw, found in the
hardware bag, into place and
then tighten all three screws.
Partially install two light kit
screws, found in the
hardware bag, halfway into the
motor housing as shown. It does
not matter which two screw holes
you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Connect the single-pin connectors from the
LED assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together. Align the
keyhole slots in the light kit housing with the
two screws. Make sure all the wires from the
fan and the light kit are snug inside the center
of the light kit, not pinched in between the upper
switch housing and the light kit or hanging out
of the sides. Install two of the light kit screws
found in the bag.
2 of 2
Short Light Kit
Screw
BAG
Fan style may vary.
Note:
Feed the wire plugs through the
center hole of the upper switch
housing and gasket, then wrap
keyhole slots around the screws
and twist counterclockwise.
Loading ...
Loading ...
Loading ...