Loading ...
Loading ...
Loading ...
4
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote Troubleshooting
Installing the Ceiling Bracket
Use wood screws and
washers (included) when
securing to support structure
with approved electrical
outlet box. Drill 9/64” pilot
holes in support structure
to aid in securing ceiling
bracket with hardware found
in the hardware bag.
Use machine screws (provided
with outlet box) and washers
when securing to existing ceiling
fan-rated outlet box. Make sure
it is securely installed and is
acceptable for fan support of 31.8
kg (70 lbs) or less.
Option 2:
Wood Screws
Option 1:
Machine Screws
OFF
Turn Power
Do this rst!
The machine screws are the ones
that came with your outlet box.
Hunter Pro Tip:
For angled ceilings,
point opening
toward peak.
ANGLED
MOUNTING TIP
BAG
Wood Screw
Washer
x2
x2
You have two options for installation. Pick which one works best for your location. Remove
any existing bracket prior to installation. Only use the provided Hunter ceiling bracket that
came in your fan’s box.
Installing the Downrod
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
1
STEP
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.
K
E
E
P
!
2
STEP
Remove the pre-installed
setscrew so that the
downrod can be inserted.
3
STEP
Pass all wires to one side of horizontal bar in
downrod assembly. Hand tighten the downrod
(at least 4–5 full turns) until it stops. Trim the
wires coming from the fan so that 8-inches
remain coming from the top of the downrod.
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
8”
3/8”
C
U
T
&
S
T
R
I
P
(not to scale)
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
5
STEP
4
STEP
6
STEP
Lower the adapter cover until it rests ush
against the motor housing.
The wires can be cut, but leave at least 8”
extending from the top of the downrod.
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
Fan style may vary.
Note:
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK
the setscrew is tight using pliers
each time you change fan direction.
Loading ...
Loading ...
Loading ...