Loading ...
Loading ...
Loading ...
TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING
WHAT’S WRONG? WHAT TO DO…
Viscosity of material is too high. Thin material per manufacturer
recommendation.
TROUBLE! ATOMIZATION IS TOO COARSE
WHAT’S WRONG? WHAT TO DO…
Viscosity of material too high. Thin material per manufacturer
recommendation.
Flow control knob setting too high Decrease flow control setting
Material accumulated /clog inside nozzle Clean
Air inlet blocked Clean or change air filter
Container loose Screw container tightly in place
Container lid loosen
Screw container lid tight in place
TROUBLE! SPRAYER PULSATES.
WHAT’S WRONG? WHAT TO DO…
Air filter clogged Clean or change air filter
Material in container almost empty. Refill container.
Container loose Screw container tightly in place
Container lid loosen
Screw container lid tight in place
TROUBLE! SPRAY MATERIAL DOES NOT COVER PROPERLY
WHAT’S WRONG? WHAT TO DO…
Flow control knob setting too low. Increase flow control setting
Clearance to target area too large Reduce spray distance
Too few spray paths sprayed over target area Apply more spray paths sprayed over target
area
Viscosity of material too high. Thin material per manufacturer
recommendation.
Have you tried the recommendations above and are still having problems? In the United States,
to contact to a customer service representative, mail our Technical Service at
service.batavia@outlook.com 24/7. We will get back to you within 24 hours.
Loading ...