Loading ...
Loading ...
Loading ...
14GB
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.
•Before connecting the speakers, turn the unit off.
•Use speakers with a 2 impedance or 4 to 8
impedance, and with adequate power handling
capacities to avoid damage.
Subwoofer direct connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker lead.
To enable the connection, set [Subwoofer Direct] in
[Advanced] to [1] to [3].
Note
Use a subwoofer with a 2 impedance or 4 to 8
impedance, and with adequate power handling capacities
to avoid damage.
Speaker connection for high volume
playback
For high volume playback, you can connect front
speaker in parallel.
For this connection:
– Set [Speaker Impedance Load] in [Advanced] to
[2 Ohm].
– Connect the subwoofers to right and left rear
speaker leads or use a dual voice coil subwoofer
with 4 to 8 impedance.
Notes
• When using a subwoofer with dual voice coil, or using
subwoofer(s) by connecting to the right and left rear
speaker leads, be sure to set [Speaker Impedance Load] in
[Advanced] to [2 Ohm].
• To exert the speaker's potential, make the power
connection to the battery directly (page 13).
To capture your voice during handsfree calling, you
need to install the microphone .
Cautions
•It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
•If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 is
required before use.
1 To enable the steering wheel remote control, select
[General] [Steering Control] [Custom] to
make the registration.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1
• Refer to the support site on the back cover for details then
connect each lead properly to the appropriate leads.
Making an improper connection may damage the unit.
• Consulting the dealer or an experienced technician for
help is recommended.
Connecting the speakers
Front speaker
Subwoofer
FL
FR
RR
RL
Front speaker
(4 Ω to 8 Ω)
Rear speaker
(4 Ω to 8 Ω)
Subwoofer
(4 Ω to 8 Ω, dual voice
coil type)
Installing the microphone
Using the wired remote control
Clip (not supplied)
Loading ...
Loading ...
Loading ...