Loading ...
Loading ...
Loading ...
ASSEMBLYINSTRUCTIONS
UPPER
See Page 11 for Illustration
1.
Connect the Upper Swing Arm (L) (18) to the left Lower Swing Arm and
connect the Upper Swing Arm (R) (19) to the right Lower Swing Arm, and
secure them with six Hex Head Bolts (106), four Curved Washers (143) and six
Nyloc Nuts (129) by using the Wrenches (151 & 152).
" ' F
#106.5/16" x 1-3/4"
Hex Head Bolt (6 pcs)
#129.5/16"x 7T
Nyloc Nut (6 pcs)
#143.5/16"x 23mm
x 1.5T Curved Washer
(4 pcs)
PLASTIC
See Page 11 for Illustration
1. Attach front (89) and rear (90) Handle Bar Covers together on left Swing Arm
shaft, and secure using two Sheet Metal Screws (122) and the Phillips Head
Screw Driver (150). Repeat this process on the right side with Handle Bar
Covers (91) and (92).
2. Install Console Mast Covers (L & R) (81 & 82) on each side of the Side Cases
and secure with two Sheet Metal Screws (122) and the Phillips Head Screw
Driver (150).
3. Secure left Slide Wheel Cover (87) on left Pedal Arm with two Phillips Head
Screws (120) and the Phillips Head Screw Driver (150). Repeat this process for
the right Slide Wheel Cover (88).
4. Snap Rear Bar Cover (97) into the hole on the Incline Rail Assembly.
i _
#120. M5 x 15ram
Phillips Head Screw
(4 pcs)
#122. f_3.5 x 12mm
Sheet Metal Screw
(6 pcs)
E20 / E25 ELLIPTICAL 10
Loading ...
Loading ...
Loading ...