Loading ...
Loading ...
Loading ...
ASSEMLYINSTRUCTIONS
&CONSOLE
See Page 9 for Illustration
1. Connect the Front Stabilizer Bar (2) with the Main Frame at the front joining
plate by using the Wrench (1S1) to tighten two Hex Head Bolts (112), two
Split Washers (142) and two Curved Washers (144).
2. Connect the Rear Stabilizer (3) with the Main Frame at the rear joining plate
by using the Wrench (151) to tighten two Hex Head Bolts (112), two Split
Washers (142) and two Curved Washers (144).
3. Pull the wire, which is attached to the Computer Cable (38), out of Console
Mast (1S) and secure the mast on the Main Frame by using the M8 L Allen
Wrench (1S3) to tighten four Socket Head Cap Bolts (113) together with four
Split Washers (142) and four Flat Washers (139).
4. Plug in the connectors of the Computer Cable (38) and two Handpulse with
Cable Assemblies (White & Red) (44, 45) on the back of the Console Assembly
(3S) and secure the Console Assembly (3S) on the console holding plate with
four Phillips Head Screws (119) by tightening them with Phillips Head Screw
Driver (150).
• i
#112.3/8"x 3-3/4" Hex
Head Bolt (4 pcs)
#11:3.3/8"x 3/4"
Socket Head Cap Bolt
(4 pcs)
#119. M5 x lOmm
Phillips Head Screw
(4 pcs)
#1:39.3/8"x 19mm x
1.5T Flat Washer (4 pcs)
#142.3/8"x 2T
Split Washer (8 pcs)
#144.3/8"x 23 x 2T
Curved Washer (4 pcs)
LOWER
See Page 9 for illustration
1. Attach the Lower Swing Arms (L) and (R), (12) and (13), on each side of
Console Mast shaft and secure with two Hex Head Bolts (104) and two Flat
Washers (138) by using the Wrench (1S2).
2. Insert the shaft of the left Connecting Arm (10) through the bushing on left
Pedal Arm (7) and secure with a Button Head Socket Bolt (115) together with
a Flat Washer (138) by using M5 L Allen Wrench (149). Do it the same way for
right Connecting Arm (11) and right Pedal Arm (8).
3. Remove the Rod End Shafts (20) which are pre-assembled on the left and
right Connecting Arms. Assemble the Connecting Arm with the Lower Swing
Arm and secure with Rod End Shafts (20) and the screw by using the M5 L
Allen Wrench (149).
#104.5/16"x 15mm
Hex Head Bolt (2 pcs)
#11S. 5/16"x 15mm
Button Head Socket Bolt
(2 pcs)
#138. D8.5 x 26mm x 2T
FlatWasher (4 pcs)
E20 / E25 ELLIPTICAL 8
Loading ...
Loading ...
Loading ...