Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Won't Drain/ Low voltage or using Check electrical source or call
Won't Spin/ an extension cord. electrician. Do not use extension
Wet Loads cords.
(cont,)
Cold rinses. Cold rinses leave loadswetter than
warm rinses. This is normal.
Continues Drain hoseis less than Raise the drain hose(see
to Fill/ 39 in (99 cm) above floor. "Installation Instructions,"Section A).
Continues
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit
Cycle Stuck standpipe. (see "Installation Instructions,"
Section C).
Drain hosetaped into Do not seal off drain hose with tape.
standpipe. The drain hoseneeds an air gap.
Washer Makes Load isunbalanced. Redistribute load.
Noise
Washer is not level. Level washer. Reset rear legs
Rear leveling legs not set. (see "Installation Instructions,"
Section G).
Nuts on front feet not tight. Tighten nuts (see "Installation
Instructions," Section G).
Yellowshipping strap with Remove strap with cotter pins
cotter pins not completely (see "Installation Instructions,"
removed. Section B),
Floor not strong enough Relocate washer (see "Installation
to support washer. Instructions," Section A).
Gears engaging after drain This is normal.
and before spin.
Upper part of agitator dicks This is normal.
during wash.
Won't Waterinlet valve Clean screens.
Fill/Won't screens are plugged.
Rinse/Won't
Agitate/ Water isturned off. Turnon water.
Wrong Hot and cold hoses are Reverse hoses (see "Installation
Temperature reversed. Instructions," Sections D & E).
Inlet hoseis kinked. Straighten hoses.
Timerdial is not lined up. Turntimer knob to the right slightly
and pullto start.
Power cord not plugged in. Plug in power cord.
35
Loading ...
Loading ...
Loading ...