Loading ...
Loading ...
Loading ...
NOTE: Each full turn of adjustment nut
will change mower height about 3/16".
• Recheck measurements after adjust-
ing.
BottomEdgeof BottomEdgeof
MowertoGround Mowerto Ground
AI GROUND' - TA
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-
side. if the following front-to-back
adjustment is necessary, be sure to adjust
both front linksequally so mower will stay
level side-to-side.
Toobtain the bestcutting results, the
mower housing should be adjusted so
the frontis approximately 1/8"to 1/2"
lower than the rear when the mower is in
its highest position.
Check adjustment on right side of tractor.
Measure distance "F" directly in front of
and behind the mandrel at bottom edge
of mower housing as shown.
• Before making any necessary adjust-
ments, check that both front linksare
equal in length.
• If links are notequal in length, adjust
one linkto same length as other link.
• To lower front of mower housing,
loosen nut "G" on both front links an
equal number of tums.
• When distance "F" is 1/8" to 1/2" lower
at front than rear, tighten nut "H"
against trunnion on both front links.
• To raise front of mower housing, loosen
nut"H"from trunnion on both front links.
Tighten nut=G"on both front linksan
equal number of turns.
• When distance=F" is 1/8" to 1/2" lower
at front than rear, tighten nut "H"
against trunnion on both front links.
NOTE: Each full turnof nut"G" will
change dim. "F"by approximately 3/8".
• Recheck side-to-side adjustment.
\
_x\ \\ I * 'l' Mandrel
BOTH FRONT LINKS MUST BE
EQUAL IN LENGTH
Nut "G"
Front Plate Trunnion
Assembly
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
1. Park tractor on a level surface.
Engage parking brake.
2. Lower mower to its lowest position.
3. Disengage belt tension rod from lock
bracket.
_l, CAUTION: Rod is spring loaded. Have
a firm grip on rod an remase slowly.
4. Remove screws from R.H. mandrel
cover and remove cover.
5. Remove any dirt or grass clippings
which may have accumulated around
mandrels and entire upper deck
surface.
6, Disconnect R.H. suspension arm from
rear deck bracket by removing
retainer spring.
7, Carefully roll belt over the top of R.H.
mandrel pulley.
8. Remove belt from electric clutch
pulley.
9, Remove belt from idler pulleys,
1O,Check primary idler arm and two
idlers to see that they rotate freely.
11.Be sure spring is securely hooked to
primary idler arm and spring arm,
MOWER DRIVE BELT INSTALLATION
12.Install belt in both idlers,
13.Install new belt onto electric clutch
pulley.
14,Carefully roll belt into upper groove of
R,H, mandrel pulley,
15,Carefully cheek belt routingmaking
sure belt is in the grooves correctly,
16.Reconnect R.H. suspension arm to
rear deck bracket with retainer spring.
17.Reassemble R,H. mandrel cover,
18. Engage belt tension rod by pushing
rod into locking bracket.
26
Loading ...
Loading ...
Loading ...