OPERATING INSTRUCTIONS
Air scrubber
A600
A1200
Revision 1
1
Introduction
Dear Customer,
Thank you for choosing Ermator as your supplier.
We hope that the Ermator air cleaner will be to your satisfaction and meet your expectations.
Ermator has been manufacturing professional dust extractors since 1966 and has over the years
acquired a genuine technical knowledge in this area. We continuously strive to improve in our
product segment and will continue to supply the market with new equipment.
Notice!
These instructions are only for the air cleaner type Ermator A600/A1200.
The air cleaner, Ermator A600/A1200 can only be used with dry, non-explosive materials.
Ermator will not be held responsible if the air cleaner is used for other applications or has been
used in ways other than those outlined in this instruction manual.
Before using the machine, please read the safety regulations carefully.
Read the complete instruction manual before using the Ermator A600/A1200.
All spare parts used for the Ermator A600/A1200 must those specified by Ermator AB.
Revision 1
2
Unpacking
When unpacking the machine, please check that the air cleaner has not been damaged in transport.
Safety Instructions
Handling
Warning
Cables damaged through crushing or splitting can be dangerous if used and should be replaced
immediately. Risk of personal injury.
Warning
Do not connect the machine to an unearthed socket. Risk of personal injury.
Warning
Make sure the assembly area is firm, so the air cleaner does not tip over. Risk of personal and
material injury.
Warning
Risk of pinching when handling the toggle fastener.
Warning
The machine must not be used in environments where explosive gases may be present. Serious
risk of explosion
Warning
The machine should be turned off at the switch before releasing the power lead from the wall
outlet. If the switch is in the on position, a spark can occur between the contact on the power
lead contact.
Service
Warning
Remove the plug from the wall socket when carrying out maintenance work. Risk of personal
injury.
Warning
Dust that is hazardous to health can be spread when the coarse filter and the absolute filter are
replaced. Accordingly, the user should wear protective glasses, protective gloves, and a
breathing mask conforming to protection class FFP2
Warning
Do not puncture the absolute filer. Risk of dust dispersion.
Revision 1
3
Function
Connect the lead to the power outlet, attach the outlet hose if available. Start the machine by pressing
the start knob. The air cleaner has two speeds.
The air cleaner separates material in two stages:
The first stage uses a coarse filter. This traps the bigger particles and acts as protection for the main
filter. The coarse filter should be changed on a daily basis.
The second absolute filter separates the unhealthy dust that is invisible to the eye.
Coarse filter characteristics
The coarse filter is strong and easy to change. It has low pressure drop and good separation capability.
The coarse filter takes care of big particles and acts as protection for the absolute filter.
Main filter characteristics
The main filter is an absolute filter with class HEPA H13 that is dimensioned for fine, dry dust and
should be preceded by a pre-filter.
Caution
The operating life of the absolute filter decreases and can be completely destroyed if exposed
to water.
Caution
The absolute filters cannot be cleaned and must be replaced when full.
Filter indicator
A600/A1200 has two filter indicators connected to a warning light which measures the pressure drop
over the filter. If the pressure drop is too high, a orange lamp light up, indicating that the absolute
filter should be changed. Using the air cleaner when light is showing will reduce the effectiveness of
the machine. When the pressuredrop is too low, a red lamp will light up, indicating that the Hepa filter
is leaking/damaged and needs to be replaced immediately.
Fan
The air cleaner is equipped with a single, 1 phase fan.
Risk of dust dispersion - Use of personal safety equipment
Unhealthy dust can be spread when cleaning the coarse filter and during filter change.
Accordingly, the user should wear protective glasses, protective gloves, and a breathing mask
conforming to protection class FFP2.
Revision 1
4
Accessories
PART NO. DESCRIPTION No./machine Machine
200900275 Coarse filter 1 pc A600
200700532 Hepafilter 1 pc A600
200900224 Coarse filter 1 pc A1200
10085 Hepafilter 1 pc A1200
Contact your local representative for other spare parts.
Warranty
All Ermator devices and accessories have a 12-month factory warranty for material and manufacturing
defects. When returning the attached warranty slip, the warranty extends to 36 months. Do not
attempt to repair the suction apparatus without the consent of the manufacturer.
The warranty does not cover defects which are the result of normal wear and tear, negligence,
defective use, unauthorised repair or the suction apparatus being connected to the incorrect voltage.
In the event of any complaint, the suction apparatus or an agreed part of it must be returned to us or
our authorised representative for warranty examination and for any warranty repair or replacement.
Revision 1
5
PROBLEM SOLVING
The A600/A1200 is designed and manufactured for a severe environments and tasks, but the user must
note that the machine components must be protected from knocks and blows. Filter and sealing
connections are carefully chosen to serve the operator. Therefore, the machine must be handled with
care if it is to work correctly for many years.
Problem Cause Procedure
The fan does not start No power Connect the machine
Cable defective Change
Switch defective Change
The fan stops immediately Wrong fuse Connect the correct fuse
The fan runs, Blocked filter Change filter
but suction is poor Cover loose Adjust
Sealing defect Change current seal
Dust blows from unit Defective or loose filter Adjust or change
Abnormal noise Order service
Keep these instructions!
Revision 1
6
TECHNICAL DATA
Air cleaner A600 A1200
Voltage 120 VAC (1-phase) 120 VAC (1-phase)
Max power output 400 W (full speed) 600 W (full speed)
Max Airflow 2 speed 1000 m
3
/h 2000 m
3
/h
Pre filter size 0,16 m
2
0,64 m
2
HEPA FILTER
Filter classification H13 H13
Filter Area 3,5 m
2
10,5 m
2
Sound level 2 speed 58 / 65 dB(A) 60 / 68 dB(A)
Sound level LxWxH (mm) 465x385x466 724x424x810
Weight 20 kg 38 kg
Revision 1
7
OM ÖVERENSSTÄMMELSE
DECLARATION OF CONFORMITY
DECLARATION DE CONFORMITÉ
ERKLÄRUNG DER ÜBERSTIMMUNG
SAMSVARSERKLRING
Pullman Ermator AB
Industrivägen 10
S-777 34 SMEDJEBACKEN
Försäkrar under eget ansvar att maskinen
Declare under our sole responsibility that the machine
Certifie sous sa propre responsabilité que le produit ciaprès
Versichern auf eigener verantwortung, dass das Produkt
Forsikrer under eget ansvar at maskinen
A600 Nr./No: 0900061a0001-xxxx
A1200 Nr./No: 0900062a0001-xxxx
Tillv.år/Manufact.year/Baujahr: 2010-
som omfattas av denna försäkring är i överensstämmelse med standarder:
included in this declaration, follows the provisions of the:
est conforme aux aux normes suivantes:
den folgenden Normen entspricht:
er i overensstemmelse med standarder:
SS-EN 292-1, SS-EN 60 204-1 (1993.11.30)
SS-EN 55011:1989
SS-EN 50082-1
SS-EN 60335-1, SS-EN 60335-2-69 & A1
enligt villkoren i/according to/selon/laut/i henhold til vilkårene i
Machine Directive 98/37/EEG
Low Voltage Directive 73/23/EEG
EMC Directive 89/336/EEG
SMEDJEBACKEN 2006.01.01 Torbjörn Bengtsson
VD
General Manager
Revision 1
8
A600
Revision 1
9
A600
POS.
QTY.
NUMBER
DESCRIPTION
1
1
200900275
Pre-filter A1000 12x12x1 inch ex.A600&A1000
2
1
201000340
Front frame cover for A1000&A600
3
1
200700532
Filter
4
1
201000415
Front fan cover assembly ex.A600&A1000
5
1
201000416
Fan assembly set ex.A600 120v
6
1
201000417
Air outlet set ex.A600&A1000
7
1
201000418
Pressure sensor set ex. A-line
8
1
201000418a
Pressure sensor set ex. A-line
9
1
201000419
Handle set ex.A600&A1000
10
1
200900311a
Sound alarm 80dB yellow lamp
11
1
200900311
Sound alarm 80dB red lamp
12
1
201000420
Relay Set ex.A600
13
1
201000421
Backside plate set ex.A600 120v
14
1
6362109
Switch
15
1
201000133
Counter set
16
1
201000422
Cable fix set
17
1
200900336
Power core set 16AWG X3C 120v
18
1
201000339
Power Inlet Kit ex. A-line
19
1
201000423
Capacitor 25uF
20
1
201000424
Capacitor 100uF
21
1
201000425
Al frame box ex A600&A1000
22
2
201000426
Lock set ex. A600&A1000
23
1
200900295a
Cable kit A600 120v
Revision 1
10
A1200
Revision 1
11
A1200
POS.
QTY.
NUMBER
DESCRIPTION
1
1
200900224
Pre-filter of A1200&A2000
2
1
201000299
Front frame cover ex.A1200&A2000
3
1
10085
Filter ex.A1200&A2000
4
1
201000335
Front fan inlet cover ex.A1200&A2000
5
1
201000336
Fan assembly set ex.A1200
6
1
201000427
Air outlet set ex.A1200&A2000
7
2
201000428
Pressure sensor set (0-500) ex.A1200&A2000
8
1
200900311a
Sound alarm 80dB yellow lamp
9
1
200900311
Sound alarm 80dB red lamp
10
1
201000429
A1200&A2000 main box
11
1
201000430
Relay set ex.A1200
12
1
201000423
Capacitor 25 set
13
1
201000424
capacitor 100 set
14
1
201000431
Backside plate set ex.A1200
15
1
6362109
Switch
16
1
201000133
Counter set
17
1
201000422
Cable fix set
18
1
200900336
Power cord set 16AWG X3C
19
1
201000339
Power Inlet ex. A-line
20
2
201000338
Handle set ex.A1200&A2000
21
1
201000337
Carrier assembly
22
4
201000432
Wheel set ex.A1200&A2000
23
1
200900329a
Cable kit ex.A1200
24
1
201000280
Wheel frame assembly kit
25
4
200900306
Lock of A2000
Revision 1
12
Notes
______________________
______________________
______________________
______________________
______________________
______________________
______________________
______________________
______________________
______________________
______________________
______________________
______________________
Revision 1
1
Revision 1
2
