Loading ...
Yoursafety and the safety of
others is very important.
We haveprovided many important
safety messagesin this manualand
on your appliance. Always readand
obey all safety messages.
This is the safety alertsymbol.
This symbol alertsyou to
potential hazardsthat can kill
or hurt you and others. All safety
messageswill follow the safety alert
symbol and either the word "DANGER"
or "WARNING".Thesewords mean:
Youcan be killed or seriouslyinjured
if you don'tfollow instructions.
All safety messageswill tell you what
the potential hazardis, tell you how to
reducethe chance of injury, andtell
you what can happenif the
instructions are not followed.
Important: Observe all governing
codes and ordinances.
Proper installation isyour
responsibility:
• Have a qualified technician install
this range hood.
• Comply with installation clearances
specified on the model/serial rating
plate.
Model/serial rating plate is located
inside the range hood on the rear
wall.
Island canopy hood location should
be away from strong draft areas, such
as windows, doors and strong heating
vents.
Grounded electrical outlet is required.
See "Electrical requirements;'
Note:The island canopy hood is
factory set for venting through the
roof or wall. For non-vented
(recirculating) installationssee "Non-
Vented (Recirculating) Kits" on the
back page.
All openings in ceiling and wall where
range hood wUl be installed must be
sealed.
WARNING -- TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK,
OR INJURYTO PERSONS,
OBSERVE THE FOLLOWING:
Installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
applicable Codes and Standards,
including Fire Rated
Construction. The combustion
airflow needed for safe
operation of fuel-burning
equipment may be affected by
this unit's operation. Follow the
heating equipment
manufacturer's guideline and
safety standards such as those
published by the National Fire
Protection Association (NFPA),
and the American Society of
Heating, Refrigeration and Air
Conditioning Engineers
(ASHRAE), and the local code
authorities.
When cutting or drilling into wall
or ceiling, do not damage
electrical wiring and other
hidden utilities.
Ducted fans must always be
vented to the outdoors.
WARNING --To reduce the risk
of fire, use only metal ductwork.
This unit must be grounded.
Tools needed:
level drill
1-1/4" drill bit
measuring
tape or ruler
wire stripper
or utility knife
allen wrench set
Partsneeded:
2 U.L.- or C.S.A.- listed, 112" (12.5 mm}
conduit connectors
power supply cable
1 wall or roof cap
metal vent system
Partssupplied:
8 trim
_w support clipss mounting
bracket support
system
upper
chimney
trim
!
lower
chimney
trim
mounting
template
upper
upper .._chimney
chimney ltri m
J
lower
chimney
11 lower
II chimney
U trim
caulking gun and
weatherproof
caulking
compound
saber or
keyhole saw
duct ta_
screwdriver
metal _'_
screwdriver
Loading ...
Loading ...
Loading ...