Loading ...
Loading ...
Loading ...
(387,1)
北米Model "A2620BE-B" EDITED: 2022/ 6/ 24
. If the engine could overheat because
of a temperature increase of the engine
coolant, it may not be possible to
activate X-MODE. Even while X-MODE
is activated, X-MODE will be deacti-
vated when the engine coolant tem-
perature increases.
. The Auto Start Stop system will be
stopped while X-MODE is activated.
Models with 2 modes:
. SNOW/DIRT is suitable for driving
on a snow-covered road where the
points of contact between the tires
and road surface are visible, or for
driving on an unpaved road.
. DEEP SNOW/MUD is suitable for
driving on a road covered with deep
snow where the points of contact
between the tires and road surface are
not visible, or for driving on a muddy
road.
. If the vehicle speed reaches 25 mph
(40 km/h) or more while X-MODE is
activated, a buzzer will sound once and
X-MODE will be deactivated. When you
use the cruise control after X-MODE is
automatically deactivated, X-MODE will
not be automatically reactivated when
the vehicle speed drops below 22 mph
(35 km/h).
& Hill Descent Control Function
s07bi03
The hill descent control function will be in
standby mode when X-MODE is activated
and the vehicle speed is less than approxi-
mately 12 mph (20 km/h).
The function will operate when the vehicle
speed is less than approximately 12 mph
(20 km/h) and the accelerator ratio is less
than approximately 10%.
The function will turn off when the vehicle
speed is more than approximately 12 mph
(20 km/h) and the accelerator pedal is
depressed.
CAUTION
The braking power of the hill des-
cent control function may not be
sufficient when strong braking
power is needed (e.g., when towing
a trailer).
NOTE
. Even while the hill descent control
function is operating, you can vary the
vehicle speed using the brake pedal or
accelerator pedal.
. During braking by the hill descent
control function, the stop lights will
illuminate.
. The hill descent control function is
operable regardless of the gradient of
the road.
. The hill descent control function
may be considered normal when the
following conditions occur.
– An operating sound is heard
briefly from the engine compart-
ment while the hill descent control
function is operating.
– The sensation of depressing the
brake pedal is different, (harder than
usual etc.) when the brake pedal is
depressed during hill descent con-
trol function operation.
! Hill descent control indicator
s07bi0301
This indicator appears while the hill des-
cent control function is in the standby
mode. It flashes while the function is
– CONTINUED –
X-MODE (Outback/Subaru Outback Wilderness)
385
7
Starting and Operating
Loading ...
Loading ...
Loading ...