Loading ...
Loading ...
Loading ...
_hb ARNING: Always wear
safety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
2 - 1/2 inch wrenches
(or adjustable wrenches)
2 - 9/16 inch wrenches
(or adjustable wrenches)
2 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
/'-"-4
o
Figure 1
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References to the right or left hand side of
the snow thrower are from the viewpoint
of the operator's position behind the unit.
_r Drive Lever
Shifter Lever
Traction
Drive Lever
Chute
Deflector
Height
Adjust
Skid
Figure 2
TO REMOVE SNOW THROWER FROM
1. Locate all parts packed separately 5.
and remove from the carton.
NOTE: Place fuel stabilizer in a safe
place until needed for storage.
2. Remove and discard the packing ma- 6.
terial from around the snow thrower.
3. Cut down all four corners of the carton 7.
and lay the panels flat.
4. For shipping purposes, the height ad-
just skids are attached to the pallet.
Remove the screw that secures each
height adjust skid to the pallet. See
Figure 2.
F-O41074L 7
CARTON
Roll snow thrower off the pallet by
pulling on the lower handle.
CAUTION: DO NOT back over con-
trol cables.
Remove all packing material from the
unit.
Cut ties securing the clutch control
cable to the lower handle and lay
cable back away from the motor
frame.
Loading ...
Loading ...
Loading ...