Loading ...
Loading ...
Loading ...
[.,,."]_e,,_ r*..1ZIB]I'_"_
Auger Drive Belt
If your snow blower will not discharge
snow, check the control cable adjust-
ment. If it is correct, then check the
condition of the auger drive belt. If it is
damaged or loose, replace it (see "How
To Replace The Belts" in this section of
the manual).
1. Disconnect spark plug wire.
2. Remove screw from belt cover,
Remove belt cover (see Figure 36).
Belt Cover
ure 36
Loosen nut on auger idler pulley
and move auger idler pulley towards
belt about 1/8 inch (3 mm) (see
Figure 40).
4.
5.
6.
7.
Tighten nut.
Have someone engage auger drive
clutch. Check tension on belt (op-
posite idler pulley). Belt should de-
flect about 1/2 inch (12.5 mm) with
moderate pressure (Figure 37). You
may have to move idler pulley more
than once to obtain the correct ten-
sion.
Auger
Drive
f _ Engine
k A Pu,ey
, J \\O 1/2 inch
';,_ _ (12.5mm)
idler_..._C F ..7\\f'f" Deflection
Pulley 70, " "_
Engaged _ ",,_
Figure 37
Reinstall belt cover.
Whenever belts are adjusted or re-
placed, the cables will need to be
adjusted. (See Cable Adjustment in
this section of the manual).
8. Attach the spark plug wire.
F-041074L 27
Loading ...
Loading ...
Loading ...