Craftsman 917376658 Rotary Lawn 625 Series Briggs & Power-Propelled 22" Multi-Cut

Owner's Manual - Page 17

For 917376658. Series: 625 Series
Also, The document are for others Craftsman models: 917.376658

PDF File Manual, 48 pages, Read Online | Download pdf file

917376658 photo
Loading ...
Loading ...
Loading ...
Jasy lasrue-
unamanguera
:loraamenos
enciador,el
stuntapados
iua.Elaguaen
_,ci6nde6ste.
,:RTA DE LA
la impulsi6n pot
rada, Raspe de-
illo para masitta
_, para remover
_sura en la parte
Isi6n.
,qmotor
Correa de
mando
IMPULSION
7nandoen la
_e ia pantalla
e la nueva
;I orificio en el
.ra del desperdF
ci6n vertical.
stale la correa
le engranajes.
)robada por la
_e y dure
_pulsi6n.
una posici6n
ntaje en el
)ntro para
/ conexi6ne(s) el
mango inferior.
quilla de fa
i det mango.
;ia dentro para
montaje
_cima para
de horquilla por
_ntaje,
ENGINE
FUEL SYSTEM
IMPORTANT: It is important to prevent
gum deposits from forming in essential fuel
system parts such as carburetor, fuel filter,
fue! hose, or tank during storage. Alcohol
blended fuels (called gasohol or using
ethanol or methanol) can attract moisture
which leads to separation and formation
of acids during storage_ Acidic gas can
damage the fuel system of an engine while
in storage_
o Empty tile fue! tank by starting the en-
gine and letting it run until the fuel lines
and carburetor are empty,
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
o Use fresh fuel next season°
NOTE: Fuel stabilizer is an acceptable al-
ternative in minimizing the formation of fuel
gum deposits during storage, Add stabilizer
to gasoline in fuel tank or storage container,
Always follow the mix ratio found on stabilize r
container. Run engine at least 10 minutes
after adding stabilizer to allow the stabilizer to
reach the carburetor. Do not empty the gas
tank and carburetor if using fuel stabilizer,
ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE" in
tile Maintenance section of this manual),
CYLINDER
1, Remove spark plug,
2, Pour one ounce (29 ml) of oil througi7
spark plug hole into cylinder°
3, Pull starter handle slowly a few times
to distribute oil,
4, Replace with new spark plug.
OTHER
o Do not store gasoline from one season
to another°
Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
o If possible, store your unit indoors and
cover it to protect it from dust and dirt.
° Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic.. Plastic cannot
breathe, which allows condensation to
form and will cause your unit to rusL
IMPORTANT: Never cover mower while
engine and exhaust areas are still warm.
_CAUTION: Never store the lawn mower
with gasoline in the tank inside a building
where fumes may reach an open flame
or spark, Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTING - See appropriate section in manual unless directed
to a Sears Parts & Repair Center.
PROBLEM CAUSE
Does not start
1. Dirty air filter°
2. Out of fuel.
3. Stale fuelo
4. Water in fuel.
5. Spark plug wire is
disconnected.
6o Bad spark plug,
7., Loose blade or broken
blade adapter.
8. Control bar in released
position.
9. Control bar defective.
I0,, Fuel valve lever (if so
equipped) in OFF position.
11_Weak battery (if equipped).
12. Disconnected battery
connector' (if equipped)°
I.
2_
3.
4,
5.
6_
7,,
8.
9.
17
CORRECTION
Cleanlreplace air filter.
Fill fuel tank.
Empty fuel tank and refill tank
with fresh, clean gasoline.
Empty fue! tank and refill tank
with fresh, clean gasoline.
Connect wire to plug,
Replace spark plug.
Tighten blade bolt or
replace blade adapter_
Depress control bar to
handle,
Replace control bar°
lO.Turn fuel valve lever
to the QN position.
11. Charge battery.
12.Connect battery to engine.
Loading ...
Loading ...
Loading ...