Loading ...
Loading ...
Loading ...
cAoT,o.A1
CAUTION: TO REDUCE THE RiSK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER
SERVlCABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PROFESSIONALS.
The model number of this product may be found on
the back of the unit; the serial number of the label
affixed to the back of the unit,
You should note the model and serial numbers of
this unit in the space provided. Retain this booklet
as a permanent record of your purchase to aid in
identification in the event of theft.
MODEL#
SERIAL#
1. Your Washer-Dryer spins at a high 1000 rpm spin speed, which will extract more water
especially from absorbent fabrics and reduce the degree of dampness as the machine goes into
the drying mode.This will cut down on your drying time.
2. FABRIC SOFTENER: After the wash cycle, the clothes can get stuck to the sides of the drum.
USING LIQUID FABRIC SOFTENER WILL CAUSE THE CLOTHES TO UNSTICK IMMEDIATELY
AND TUMBLE IN THE DRY CYCLE. THIS HELPS DRY CLOTHES FASTER AND CAUSES LESS
WRINKLES.
3. OVERLOADING: The drum has a capacity of 13 Ibs (1.72 cu. ft.) While this unit has one of the
largest drum available on any combination washer-dryer, it is smaller than a standard U.S. washer.
drum should not be overloaded. With too many clothes, airflow is reduced, increasing drying time.
rd
The drum should be filled to a maximum 2/3 full.
4. OVER DRYING: The condensing dryer uses cold water is used to condense the moisture from
the hot air. Since there is no external exhaust system, the moisture remains in the machine.
Frequently, when it seems the clothes are damp, it is actually the remaining moisture (like dew). Take
clothes out and within a few minutes they will be dry. Do not over dry the clothes. The exhaust system
uses air-dry.
5. USE HIGH EFFICIENCY (HE) DETERGENT: By using High Efficiency (HE) detergent, you are
preventing suds from entering the condensing chamber. When suds enter the condensing
chamber, the particles can clog up the chamber and the fan blower. Over time, this reduces
drying efficiency and may require the fan blower (impeller) to becleaned. For this and all other front
-loading/horizontal-axis units, High Efficiency (HE) detergents go a long way to improve the efficiency of
the units.
6. SORTING: When sorting laundry always take into consideration the quantity and type of fabric contained
in the load. Highly absorbent fabrics such as those used in towels or jeans will absorb more water
and become very heavy when saturated. If you notice that your clothes are taking longer than
usual to dry you may be overloading the machine, or washing too many highly absorbent articles
for a single load.
1. The unit must be installed on a strong level floor, and in protected, dry, and well-ventilated area
close to a power and water supply of sufficient capacity, and a sufficient outlet.
2. Installation on Carpet or Wood increases vibrations.
• Carpets - place on light carpet only.
, Wood - brace floor with screws and place additional sheets of plywood before installation.
3. This unit's installation and grounding should be done in accordance with local codes by a qualified
installer. "Installation Instructions" are included in this manual for the Installer's reference.
4. The unit should be plugged into a properly grounded three (3) prong electrical outlet of 110V/60Hz
with minimum 15 Amps, It should not be controlled by a wall switch or pull cord which might be
turned off accidentally.
5
Loading ...
Loading ...
Loading ...