Loading ...
Loading ...
Loading ...
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ 22
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------Safety Instructions
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
16. SAFETY INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance has a pilot. When
lighting the pilot, follow these
instructions exactly.
B.
BEFORE OPERATING
smell all
around the appliance area for gas.
Be sure to smell next to the floor
because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any gas appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas
supplier. Call the fire department.
C. Use only your hand to push in or
turn the gas control knob. Never use
tools. If the knob will not push in or
turn by hand, don’t try to repair it.
Call a qualified service technician.
Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control that has been under
water.
1. STOP! Read the safety information
on the panel above.
2. Push in gas control knob slightly
and turn clockwise to “OFF”.
NOTE: Knob cannot be turned from
“PILOT” to “OFF” unless knob is
pushed in slightly. Do not force.
3. Wait five (5) minutes to clear out
any gas. If you then smell gas.
STOP! Follow “B” in the safety
information above on this label. If
you don’t smell gas, go to the next
step.
4. Push gas control knob in
completely and turn
counterclockwise repeatedly
from “IGN” to “PILOT”. (audible
click)
5. Find pilot. The pilot is located
below the logset in the forward
right corner area of the firebox.
6. Continue to hold the control knob
in for about 10 seconds after the
pilot is lit. Release knob and it will
pop back up. Pilot should remain
lit. If it goes out, repeat steps 4
and 5.
* If knob does not pop up when
released, stop and immediately
call your service technician or gas
supplier.
* If the pilot will not stay lit after
several tries, turn the gas control
knob to “OFF” and call your
service technician or gas supplier.
7. Turn gas control knob counter
clockwise to ON, turn flame
adjustment knob counter
clockwise until flames appear.
TO TURN OFF GAS TO APPLIANCE
Push in gas control knob slightly
and turn clockwise to
“OFF.”
NOTE: Knob cannot be turned from
“PILOT” to ‘OFF” unless knob is
pushed in slightly. Do not force.
Turn manual gas supply valve off if
stove will not be used for an
extended length of time.
Pilot
Burner
Assembly
Pilot
Gas control knob
Gas control
knob
Flame adjustment
knob
Flame adjustment knob
LIGHTING INSTRUCTIONS