Loading ...
Loading ...
Loading ...
EN
Operation CFX3
28
7.13 Using the ice maker (only CFX3 55IM)
I
➤ Proceed as shown (fig. i, page 12).
Filling the ice trays with water
➤ Remove the ice trays (fig. j 1, page 13) from the ice maker housing (fig. j 2,
page 13).
➤ Remove the ice tray covers, fill with clean water and re-fit the cover, taking care to
press the edge seal all the way around.
➤ Re-position the ice trays in the ice maker housing and close the lid.
I
Removing the ice cubes
➤ Open the ice maker housing lid and lift under the front of the ice trays.
I
➤ Remove the ice tray covers and twist trays to release the ice cubes.
NOTE
• Independent of the main compartment‘s temperature setting, the
ice maker zone is designed for making ice cubes if the ice maker is
switched on.
• The cooler‘s energy consumption increases with ice maker on.
Therefore you should switch off the ice maker if it is not needed.
• The factory setting for the ice maker is OFF.
NOTE
Dry any water spillage from under the ice trays.
This will reduce ice build up under the trays and make removal easier.
NOTE
Removal may require additional force using two hands in high humidity
conditions which may create an ice bond underneath the ice trays.
CFX3_OPM_APAC(en).book Seite 28 Donnerstag, 23. Januar 2020 6:54 18
Loading ...
Loading ...
Loading ...