Loading ...
Loading ...
Loading ...
Bagless Vacuum Cleaner
SVC 510GR / SVC 511TQ / SVC 512VT (Allegro)
EN
EN-9
2019 05/2019
Ending the vacuuming process
When you nish vacuuming, switch the vacuum cleaner off by pressing the START / STOP button and then
disconnect the power plug from the socket.
To wind the power cord back to the vacuum cleaner, press and hold the winding button with one hand. Hold the
cord with your other hand to protect the vacuum cleaner input area from damage
Tip:
If the winding process stops and part of the power cord is still outside, release the winding button and
pull the cable out again by about 50 cm and press the winding button again and repeat the winding
process.
Carrying your vacuum cleaner
It is possible to hold and carry the vacuum cleaner using the handle (pic. A5) or the handle at the front of the
vacuum cleaner (pic. C1).
Caution:
Never try to carry your vacuum cleaner by holding the dust container handle!
STORAGE OF VACUUM CLEANER
Before storage you can disassemble your product to each individual part or you can store it assembled with the
tube stored in one of the parking positions.
CLEANING AND MAINTENANCE
Caution:
Before cleaning disconnect this product from the power source.
Emptying the dust container
Empty the dust container as soon as the air ow and the suction power of the vacuum cleaner decline.
1) Press the safety lock (pic. E1) and pull the dust container handle (pic. E2) up at the same time to remove the
dust container from the vacuum cleaner.
2) Place the dust container over awaste bin.
3) Press the clip on the ip-out lid (pic. E3) on the dust container and carefully remove the lid.
4) In the same way tip out the dust and dirt from the dust container into ordinary household waste. If the
container is heavily soiled you may wash the entire container under lukewarm running water. However,
before doing so, it is necessary to remove the H.E.P.Alter and its foam pre-lter from the container!
5) If the plastic conical lter becomes heavily soiled (pic. F1), we recommended that you wash the lter under
astrong water current in the shower.
6) Place the ends of the lid against the dust container and tilt the lid back so that it clicks into place.
7) Place the dust container back into the vacuum cleaner.
Caution:
Before replacing the dust container and the plastic conical filter back into the vacuum cleaner,
make sure that all parts are completely dry.
Loading ...
Loading ...
Loading ...