Loading ...
Loading ...
Loading ...
, Plastic parts: Washwith warm soapy water and wipe dry.
,A.Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
• Porcelain grates: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use non-abrasive scouring
powder for stubborn stains.
• Cooking surfaces: Ifa bristle brush is used to clean any of
the grill cooking surfaces, ensure no loose bristles remain on
cooking surfaces prior to grilling. It is not recommended to
clean cooking surfaces while grill is hot.
CAUTION
/
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER_
If you notice thatyour grill is getting hard to light or that the
flame isn't as strong as it should be, take the time to check and
clean the burner's.
CONTROLPANEL.
SPIDER WEBS
INSIDETUBE
...._: BURNER
Insome areasof thecountry,spidersorsmall insectshavebeen
knownto create"flashback"problems.Thespidersspinwebs,build
nestsandlay eggstnthegrill'sburnertube(s)obstructingthe flowof
gas to the burner.The backed-upgas canignitein the tubebehind
the controlpanel.Thisis knownas a flashbackandit can damage
your grilland evencauseinjury.
To preventflashbacksandensuregoodperformancethe burner
assemblyshouldbe removedfromthe grill andcleanedbeforeuse
wheneverthe grillhas beenidlefor an extendedperiod.
,. j
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1. Turn gas off at control knobs and LP cylinder.
2. Remove cooking grates and heat tents.
3. Remove screws and flame carryover tubes from rear of
burners.
4. Remove screw and washers to disengage burner from
bracket on firebox.
5. Remove screws to detach electrode from burner. Electrode
should remain in firebox.
6. Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
7. Wire brush entire outer surface of burner to remove food
residue and dirt.
8. Clean any blocked ports with a stiff wire such as an open
paper clip.
9. Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or
holes are found replace burner.
VERY IMPORTANT: Burner tubes must re-engage valve
openings. See illustrations at right. Correct
10. Attach electrode to burner, burner-to-valve _J
engagement
11. Carefully replace burners.
12. Attach burners to brackets on firebox. E_
13. Reposition flame carryover tubes and attach
to burners. Replace heat tents and _1_'1"
cooking grates.
464310408.9
Loading ...
Loading ...
Loading ...