Craftsman 917273221 tractor

User Manual - Page 29

For 917273221.

PDF File Manual, 64 pages, Download pdf file

Loading ...
Loading ...
Loading ...
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running,
or prevent it from starting.
Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO ADJUST ATTACHMENT LIFT
SPRING
While holding spring bushing with
wrench, loosen jam nut.
Turn adjustment bolt clockwise to
extend spring and reduce lift effort for
heavier attachments.
Turn adjustment bolt counterclockwise
for lighter attachments.
Retighten jam nut against spring bush-
ing.
IMPORTANT: Do not adjust for max-
imum spring tension when using light
attachments such as a mower. Adjust lift
lever spring to aid in lifting atachment. Do
not overpower spring. When removing
attachment, atways adjust spring tension
to its lowest position.
Adjustment Bolt
Sprin! Bushing
, Attachment
Sprin_ Tension
_, ,///
Jam Nut
TO REMOVE HOOD AND GRILL
ASSEMBLY
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
To replace, reverse above procedure.
Headlight Wiro
Connector
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the cus-
tomers expense, may be performed by
any non-road engine repair establishment
or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUSTTHROTTLE CONTROL
CABLE
The throttle control has been preset
at the factory and adjustment should
not be necessary. Check adjustment
as described below before loosening
cable. If adjustment is necessary, pro-
ceed as follows:
With engine not running, move throttle
control lever to fast position.
Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against screw.
Tighten clamp screw securely.
;peed Adjusting
Throttle
Control
Stop
Screw
Clamp Screw
Choke Control Cable
29
Loading ...
Loading ...
Loading ...