Loading ...
Loading ...
Loading ...
The blade can be tested by balancing it on a round
shaft screwdriver. Remove metal from the heavy side
until it balances evenly. It is recommended that the
blade always be removed from the adapter when
testing for balance. Before reinstalling the blade and
the blade adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade adapter
with light oil.
Be sure to install the blade with the end tips facing
up or side of the blade marked "Bottom" (or with
part number) facing the ground when the mower is
in the operating position.
Slide the blade adapter onto the engine crankshaft.
Place the blade on the adapter. Be certain the
blade is aligned and seated on the blade adapter
flanges.
Place blade bell support on blade. Make sure the
notches on the blade bell support are aligned with
small holes in the blade.
Replace hex bolt and tighten hex bolt to torque: 450
in. lbs. min., 600 in. lbs. max.
NOTE: To ensure safe operation of your mower, the
blade bolt must be checked periodically for correct
torque.
SECTION8: TROUBLESHOOTING
Problem Cause
Engine fails to start
Engine runs erratic
1. Blade control handle disengaged.
2. Spark plug wire disconnected.
3. Fuel tank empty or stale fuel.
4. Blocked fuel line.
5. Faulty spark plug.
6. Engine flooded
1. Spark plug wire loose.
2. Blocked fuel line or stale fuel.
3. Vent in gas plugged.
4. Water or dirt in fuel system.
5. Dirty air cleaner.
6. Carburetor out of adjustment.
1. Engine oil level low.
2. Air flow restricted.
3. Carburetor not adjusted properly.
1. Spark plug gap too close.
Remedy
1. Engage blade control handle.
2. Connect wire to spark plug.
3. Fill tank with clean, fresh gasoline.
4. Clean fuel line.
5. Clean, adjust gap, or replace.
6. Wait a few minutes to restart, but do not
prime.
1. Connect and tighten spark plug wire.
2. Clean fuel line; fill tank with clean, fresh
gasoline
3. Clear vent.
4. Drain fuel tank. Refill with fresh fuel.
5. Clean air cleaner.
6. Adjust carburetor.
1. Fill crankcase with proper oil.
2. Remove blower housing and clean.
3. Adjust carburetor.
1. Adjust gap to.030".
Engine overheats
Occasional skip (hesitates
at high speed
Idles poorly 1. Spark plug fouled, faulty or gap too 1. Reset gap to .030" or replace spark
wide. plug.
2. Carburetor impropedy adjusted. 2. Adjust carburetor.
3. Dirty air cleaner. 3. Clean air cleaner.
Excessive vibration 1. Cutting blade loose or unbalanced. 1. Tighten blade and adapter. Balance
blade.
2. Bent cutting blade. 2. Replace blade.
Mowerwillnotmulchgras,, 1. Wetgrass. 1. Do not mow when grass is wet; wait
until later to cut.
2. Excessively high grass. 2. Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting path.
3. Dull blade. 3. Sharpen or replace blade.
Uneven cut 1. Wheels not positioned correctly. 1. Place all four wheels in same height
position.
2. Dull blade. 2. Sharpen or replace blade.
NOTE: For repairs beyond the minor adjustments listed above, contact an authorized service dealer.
13
Loading ...
Loading ...
Loading ...