Loading ...
Loading ...
Loading ...
WARBLING: Operateth,sun,tonly,na
vvell-ventilatedoutdoor
area,Carbon monoxide exhaustfumes can be lethalin
a confinedarea,
WARNING: Avoid acddentd starting.
Make sure you are in the
starting position when pulling the starter rope (Fig. 8).
To avoid serious injury, the operator and unit must be
in a staMe position while starting.
STARTING INSTRUCTIONS
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions.
NOTE: There is no need to turn the unit on. The On/Off
Stop Control is in the ON (I) position at all times.
q
,-'ii -¸-_¸¸¸:¸¸¸¸¸¸3.
ii ii 4.
ii "
ii "
Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in
the primer bulb and fuel lines (Fig. 7). If you can't
see fuel in the bulb, press and release the bulb as
many times as it takes before you can see fuel in it.
Push the Blue EZ-Start TMLever towards the primer
bulb until it clicks and locks into place (Fig. 7).
Crouch in the starting position and do not squeeze
the throttle control (Fig. 8). Pull the starter rope out
with a controlled and steady motion up to 10
times, until the engine starts.
NOTE: The unit uses Spring Assist Starting TM, which
significantly reduces the effort required to start the
engine. You must pull the starter rope out far
enough to hear the engine attempt to start. There
is no need to pull the rope briskly-- there is no
harsh resistance when pulling. Be aware that this
starting method is vastly different from (and much
easier than) what you may be used to.
5. When the engine starts, squeeze the throttle control
for 15 to 30 seconds. This will warm up the unit. The
Blue EZ-Start TM Lever will click off automatically
when you squeeze the throttle control.
........................mFoooThe engine does not start, go back to step 2.
mFoooThe engine stops whfe you are squeezing the
throttle, go back to step 3.
mFoooThe engine stops before you squeeze the throttle
control, hold the throttle control and pull the starter
rope until the trimmer starts.
NOTE: If you are having trouble starting the unit or are
operating in extreme temperatures (below 40° F,
above 90° F), refer to the Troubleshooting section.
STOPPING iNSTRUCTiONS
1. Release your finger from the throttle control. Allow the engine
to cool down by idling.
2. Put the On/Off Stop Control in the OFF (O) position (Fig. 6).
Start/On ( I )
Stop/Off (O)
Throttle
Control
Bmue EZ-Start TM
Lever
F_g. 7
Trimmer
Starting
osition
Throttle Control/_
(Do NOT squeeze during
a standard start)
Fig. 8
Loading ...
Loading ...
Loading ...